Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic part is a right-hand integrated partial end cap for the SYMA32 handleless profile handle system, finished in Matte Inox Champagne.
A handleless profile is cut to length on site, and every cut leaves an open channel end exposed. Without a cap, that open section shows the hollow interior of the profile and interrupts the finished appearance of the cabinet front. This integrated partial end cap closes the right-hand cut end of a SYMA32 run, keeping the line clean where the profile terminates. The integrated partial form is specific to configurations where the profile does not run the full span of the cabinet front, so the termination point sits mid-installation rather than at a standard full-width end.
Matte Inox Champagne is a warm, low-sheen metallic finish that reads as a soft gold-adjacent tone, distinct from the cooler silver of Matte Silver or the deep neutral of Anthracite. It suits cabinet programs built around warm metal accents or champagne-toned hardware. As with all Rinco-Matic finish values, this finish is specific to this supplier's product line and is not a cross-brand match guarantee with any other manufacturer's champagne or inox finish. The cap is one piece, right-hand only. The left-hand cap for the same profile is a separate item.
This cap suits a cabinet installer or kitchen designer running Rinco-Matic SYMA32 profile handles in Matte Inox Champagne where a partial-span run ends on the right side. It is the detail piece that finishes the installation where the profile stops, and ordering it correctly, the right hand and the right series, determines whether the run looks deliberate or unresolved. Confirm the SYMA size on the profiles in the job before ordering, since SYMA14 and SYMA2 take their own components and are not interchangeable with SYMA32 parts.
Yes. The left-hand cap for the SYMA32 system is a separate item. Both ends of a partial run will each need their own handed cap.
No. This cap is dimensioned for the SYMA32 profile family. Each SYMA size has its own components, and they are not interchangeable.
It indicates this cap is intended for a profile run that does not extend the full width of the cabinet front, terminating at a partial-span position rather than at a standard full-width end.
This finish is Rinco-Matic's own. It is not guaranteed to match a champagne or inox finish from any other brand or system.
Order this piece to close the right-hand end of a Matte Inox Champagne SYMA32 partial profile run, and confirm the left-hand cap as a separate item if both ends need finishing.
Sold In: 1 Set