Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic end cap closes the cut ends of a SYMA32 profile handle run in an Anthracite finish. It is a finishing component specific to the SYMA32 system, keeping exposed channel sections concealed and the installed run looking intentional from end to end.
Handleless profiles arrive in long lengths and are cut to fit the cabinet run. Every cut produces an open channel cross-section at the end of the profile, exposing the hollow interior. In an installed kitchen that hollow is visible at eye level on any open end, drawer bank termination, or island run. An end cap closes that section flush, so the profile reads as a resolved detail rather than a piece of unfinished extrusion. This part is what makes the difference between a profile cut in the shop and a profile that looks like it was made to stop there.
The Anthracite finish on this cap sits in a dark, cool register that works with flat-front and slab-door cabinetry finished in dark tones, matte laminates, and two-tone kitchens pairing light carcasses with dark fronts. It is a Rinco-Matic finish value and applies to components within the SYMA32 system. Because finish names and profiles vary between suppliers, this cap coordinates only within the Rinco-Matic SYMA32 range. No cross-supplier or cross-system match is implied.
This end cap is the right choice for a cabinet shop or installer running Rinco-Matic SYMA32 profile handles in Anthracite and needing to finish the open ends of the run cleanly. It suits contemporary residential kitchens, built-ins, and commercial millwork where a handleless aesthetic is specified and Anthracite is the chosen system finish. Confirm the SYMA size on the profiles before ordering: the SYMA14 and SYMA2 sizes take their own dedicated components and are not interchangeable with SYMA32 parts.
No. Each SYMA size has its own matched components. This cap is dimensioned for the SYMA32 profile and will not seat correctly in a SYMA14 or SYMA2 profile.
It does not. Rinco-Matic and Schwinn are separate systems with different profiles and components. Parts from one system are not compatible with the other.
The product listing does not state that clips or screws are included. If your installation requires them, check the SYMA32 clip and fastener accessories available separately in the same system range.
The available data does not indicate that this end cap is handed. Confirm the product detail before ordering for a specific end condition.
For a SYMA32 handleless installation in Anthracite, this end cap is the part that turns a cut profile into a finished one. Confirm the series and finish match your profiles, then add the quantity needed for every open end in the run.
Sold In: 1 Set