Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic Gola 19 is an upper-side handleless profile in a flat form and Matte Black finish. It fits above the topmost cabinet front in a Gola 19 run, forming the recessed grip at the top of the elevation.
A handleless Gola elevation uses two distinct profile positions. Intermediate profiles sit horizontally between two fronts, gripping from the front below. The upper-side profile sits above the topmost front, where there is no second front above it, only the underside of a wall cabinet, a countertop overhang, or open space. Because the two positions face different conditions in the elevation, they use different sections and are not interchangeable. A bank of three drawers, for example, needs two intermediate profiles for the joints between them and one upper-side profile at the top. Ordering this profile covers that top position.
Matte Black is the finish that makes a Gola line disappear into the elevation. A flat, non-reflective surface reads as a continuous shadow gap along the cabinet face rather than as hardware, which is the visual logic behind a handleless kitchen. This profile is finished in Matte Black to hold that effect at the top of the run. End caps and corner pieces are separate items, specified to the Gola 19 series, and are ordered independently.
This upper-side profile suits any handleless base run, drawer bank, or tall cabinet where the topmost front's grip is at its upper edge with nothing above it. It works equally in a full-wall kitchen layout and in a single run of base cabinets. Cabinet shops specifying a Gola 19 system in matte black will pair this profile with the intermediate sections for every joint below and end caps for each cut end.
No. The upper-side and intermediate positions use different sections shaped for their specific placement in the elevation. They are not interchangeable.
Count the horizontal positions in your elevation where a front's grip sits at its top edge with no front above it. Each of those positions takes one upper-side profile, cut to the run width.
No. End caps and corners for the Gola 19 system are separate items and are ordered independently.
It is supplied in a 105-1/8 inch (2670 mm) stock length, intended to be cut to the run on site.
Order this profile for the top of every Gola 19 run in matte black, and pair it with the intermediate profiles and caps the elevation requires.
Sold In: 1 Each