Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This rear mounting bracket is the series-matched support component for Fulterer FR5000 and FR5001 pantry pull-out slides, providing the rear anchorage point that holds the slide true from back to front in face-frame and other cabinet constructions that require it.
Face-frame cabinets set the cabinet side back from the door opening, which leaves the rear of a slide without a direct side-panel surface to fasten to. A rear mounting bracket bridges that gap, giving the back of the FR5000 or FR5001 slide a solid anchor. The same need arises in frameless installs where the cabinet depth or nailer placement puts the rear slide end away from an accessible fastening surface. If your pantry cabinet construction requires rear support — and most face-frame pantry installs do — this bracket is the correct part for these slide series.
Fulterer brackets, locking hardware, and mounting components are engineered per series. This bracket is built for the FR5000 and FR5001 programs specifically. Do not use it as a substitute in FR777A, FR500, or other Fulterer series installs — the profile and hole geometry are series-matched, and a wrong-series bracket will not seat or anchor correctly. When ordering for a full pantry install, confirm the slide series first, then order the bracket that matches.
Cabinet shops running FR5000 or FR5001 pantry pull-outs in face-frame construction stock these brackets alongside the slides so the complete install goes out the door on the first trip. Missing rear hardware on a pantry pull-out means a second visit — or a slide that works loose under load over time. Contractors specifying tall pantry units in custom residential or light-commercial kitchens will want this part on the order alongside the slides themselves. It is a small component with an outsized impact on install quality when the cabinet construction demands rear support.
Not always — frameless cabinets with accessible side panels at the rear of the slide may not need a separate rear bracket. Face-frame cabinets almost always do, because the cabinet side is set back from the face. Assess your cabinet construction before ordering.
No. This bracket is matched to the FR5000 and FR5001 series. Fulterer components are series-specific — using a bracket from a different program in this series, or this bracket in a different program, is not a reliable fit.
A typical pantry pull-out uses one slide per side, so two rear brackets are needed for a complete install — one at the back of each slide. Confirm the count with your slide quantity before ordering.
This single part number covers both the FR5000 and FR5001 series, so one bracket fits either slide program in that family.
Ordering the rear mounting bracket alongside your FR5000 or FR5001 slides means the pantry pull-out goes in complete, supported front to back, and ready to carry the load it was designed for.
Sold In: 1 Each