Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 24 inch side-mount ball bearing drawer slide delivers full extension and a hold-in anti-rebound detent in a Black finish, rated 100 lb per pair. It is a practical choice wherever dark cabinet interiors, painted case goods, or modern handleless fronts call for hardware that disappears rather than draws the eye.
The Black finish makes this slide the right call for dark cabinet builds where a zinc slide would read as a visible line beside an open drawer. Think black-painted base cabinets in a modern kitchen, dark laminate shop casework, or utility storage in a garage setup where the interior finish is charcoal or espresso. The 24 inch length suits standard base cabinet drawers and deeper shop drawers. Full extension means no digging for the back of the drawer, and the hold-in detent handles the situations where a standard free-rolling slide would drift — uneven floors, drawers that get pushed shut hard, mobile shop carts.
The slide is cold-formed steel with a Black finish over the members. This is a functional indoor finish: it is durable under normal cabinet use and holds its appearance inside a closed drawer bank. Like zinc plating, it is designed for dry interior environments. The slide is not rated for wet, outdoor, or high-humidity applications. Steel ball bearings run in continuous raceways on both the cabinet member and the drawer member, so the pull stays smooth even when the drawer is carrying close to its rated load.
Cabinet shops finishing in dark palettes will find this slide eliminates a common visual mismatch — the zinc glint that shows when a drawer is open in an otherwise all-black interior. Contractors installing modern frameless cabinetry in kitchens or home offices get the same 100 lb, full-extension performance of the standard zinc version without specifying a separate finish. The 1/2 inch side clearance per side follows the same box-sizing math as the rest of the side-mount ball bearing line, so there is no change to the drawer box formula when swapping in the Black finish. The hold-in detent makes it a reasonable upgrade for shop drawers and mobile carts where a free-rolling slide is a nuisance. Sold as a pair.
No. The detent is a mechanical catch that holds the drawer closed until pulled — there is no damper and no spring. The drawer does not slow down near the end of closing travel; it simply stays put once shut. If damped soft-close is the goal, look at the Fulterer soft-close slide in the same load class.
Build the drawer box 1 inch narrower than the cabinet opening to allow 1/2 inch of side clearance for each slide. The Fulterer FR 5000-class side-mount slides are designed around that 1/2 inch clearance; the Black finish version uses the same clearance as the zinc version.
Close, but not exactly. The slide is 24 inches long (closed length) and is full extension, meaning the drawer member travels approximately the full slide length so the entire drawer clears the cabinet opening. Slide length and drawer travel are related but distinct specs — confirm your cabinet interior depth before ordering.
Yes, but face-frame installs need rear support. The back end of the slide needs a mounting point, which typically means adding rear mounting brackets. Those brackets are sold separately and must be matched to the series. Plan for them before the installation day.
Two of the same. The non-handed design means both slides in the pair are identical — either one fits either side of the drawer.
When the build calls for Black and the drawer needs to open fully and stay shut, this Fulterer 24 inch slide covers both without compromise — full extension, a clean hold-in detent, and a finish that keeps up with the rest of the cabinet.
Sold In: 15 Set
