Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Zander pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch center-to-center is a mid-size standard that covers a wide range of cabinetry without landing at either end of the scale. It is the right spacing for base drawers in the 15 to 24 inch width range, for standard upper door stiles, and for vanity drawers where the front is wide enough for a pull but not wide enough for a longer appliance-scale bar. If you are replacing existing hardware, measure between the centers of the two mounting holes: a 5-1/16 inch match means no new drilling.
The pull is cast in zinc and finished in Warm Brass. Warm Brass sits in the gold tone family but behaves differently from a polished or lacquered brass: the surface carries a softer sheen that holds its depth under kitchen and bath lighting without the hard reflections of a bright finish. On white, off-white, or greige fronts the warm undertone reads as a deliberate material choice rather than a default metal. On natural wood or walnut it picks up the grain's warmth and keeps the palette cohesive.
This pull suits a contemporary kitchen, bath, or built-in where the hardware program calls for a warm gold tone and the cabinetry is flat-fronted or lightly detailed. The slim 1/2 inch bar section keeps it in scale with shaker and slab profiles without disappearing against them. Because it belongs to the Zander collection, specifiers and cabinet shops running a full kitchen can carry the same series across door knobs, drawer pulls, and appliance-scale hardware without mixing design languages or finish tones.
Measure between the centers of your two existing holes. If that distance is 5-1/16 inches (128 mm), this pull mounts without any new drilling.
No. Warm Brass is a softer, less reflective finish than a polished brass. It has a muted sheen rather than a mirror-bright surface.
Yes. The Zander series includes companion knobs and other pull sizes in the same finish, so you can run pulls on drawers and knobs on doors within one coordinated collection.
The pull measures 6 inches (152 mm) end to end. The 5-1/16 inch figure is the center-to-center hole spacing, which is always smaller than the overall length.
Choose this pull when the hole spacing is 128 mm and the finish program calls for a warm gold tone that stays composed under light rather than competing with it.
Sold In: 1 Each