Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Benning pull is a contemporary arch-profile pull that mounts on 3-3/4 inch (96 mm) centers, one of the most common cabinet hole spacings in residential cabinetry.
The 3-3/4 inch center-to-center is the dominant hole pattern in production cabinetry. It appears on upper door fronts, base drawer fronts, and bathroom vanities across nearly every major cabinet line, which makes this pull a natural candidate for a straight replacement without recutting holes. On a mid-width drawer it lands naturally under the hand, and on an upper door it provides a grip point without pulling the eye toward the hardware. If the existing holes in your cabinetry measure 3-3/4 inches between centers, this pull mounts to them directly.
The pull is cast in zinc and finished in Matte Black. The arch profile catches light differently than a bar pull does: the curved face tilts away from the surface at its peak, so the finish reads as a flat plane from the front and picks up a slight edge shadow from the side. Matte Black specifically keeps that surface even under kitchen and bath lighting rather than introducing a specular highlight at the arc. The low sheen also makes the arch's shape the visual element rather than the finish itself, which suits a contemporary cabinet program where the hardware is meant to punctuate the front rather than dominate it.
This pull suits a contemporary kitchen, bath remodel, or built-in project where the hole spacing is already at 96 mm and the hardware finish is black. It is a practical choice for a full-kitchen replacement run, where matching the existing hole pattern across a large drawer bank avoids rework, and the Matte Black finish ties the hardware to fixtures, faucets, and appliance trim already in the room. Because it is part of the Benning collection, matching knobs and companion pieces in the same series and finish are available for doors where a single-hole fitting suits better than a pull.
A bar pull stays flat across its length. The arch curves away from the door face at its midpoint, which gives the fingertips a natural hook point and a slightly different grip angle than a straight bar.
Yes. The two values represent the same standard spacing and are used interchangeably in cabinet hardware. Both appear on this pull's spec block.
A matte finish is less likely to show water spots than a polished one, because there is no mirror surface to reflect them. As with any dark cabinet hardware, surface marks are visible but wipe off readily.
Yes. The Benning series includes companion pieces in the same design language and Matte Black finish for single-hole door applications.
When the hole pattern is already at 3-3/4 inches and the hardware program is Matte Black, this Benning pull steps in without compromise: an arch profile that reads cleanly on a flat front and a finish that holds its look under daily use.
Sold In: 1 Each