60" Solid Red Oak Tambour Door For Appliance Garages and Full-Height Openings

This Omega National SW Series tambour door is a solid red oak panel with a half round slat edge profile, sized at 60 inches long by 36 inches wide to cover taller or full-height appliance garage openings that shorter panels cannot reach.

Key Features

• Solid red oak construction gives each slat the density and grain character that red oak is chosen for in custom cabinetry.
• Half round slat edge profile produces a rounded, traditional appearance at each slat junction rather than a flat seam.
• 60" x 36" panel size is built for taller appliance garage openings where standard shorter panels fall short.
• 5/16" slat thickness provides the rigidity needed for a larger panel without adding unnecessary bulk.
• Ready to finish ships unfinished so it can be stained, painted, or clear-coated to coordinate with the surrounding cabinetry.
• Track and hardware sold separately so this panel pairs with the compatible tambour track and hardware pack for the installation.

Where This Panel Earns Its Place

A 60-inch tambour panel is the right choice when the appliance garage opening runs taller than the more common 47-inch formats, or when the design calls for a continuous roll of material across a taller wall section. Cabinet shops specifying custom kitchens with counter-height or full-height appliance garages will find this panel covers openings the shorter SW Series sizes cannot. It also suits situations where the track runs a longer arc, and a taller panel is needed to maintain full coverage at any point in travel.

Solid Wood, Grain, and Finishing Latitude

Red oak brings a pronounced, open grain pattern with warm tones that accept stain well across a wide range from light natural to deep espresso. Because this panel is solid wood rather than a veneer-backed version, the slats show consistent grain on all exposed faces and respond to finishing products the way solid oak does throughout the cabinet. The unfinished state gives the installer or finisher full control: match the stain to the cabinet door profile, apply a clear coat for a natural look, or prime and paint for a painted kitchen. The half round edge profile at each slat adds a shadow line that reads as a traditional detail, distinct from the clean seam of a flat-edge panel.

Who Specifies This Panel

Custom cabinet shops and designers working on kitchens with taller appliance garages are the primary audience here. The 36-inch width and 60-inch length put it in a size range suited to larger single-unit openings or to applications where a narrower panel in a shorter length simply will not cover the run. Homeowners finishing a renovation who need to replace or install a tambour door in an existing tall opening will also find this panel fits a gap in the standard-format market. Because it ships unfinished, it is best suited to projects where on-site or shop finishing is part of the workflow rather than a project that needs a ready-to-hang door today.

Common Questions

A Full-Height Red Oak Panel, Ready for the Finish Shop

Specify this panel when the opening is too tall for standard formats and the project calls for solid red oak with the finishing flexibility to match any cabinet finish in the room.