White Finish and Precise Fit for the Zargen Left-Hand Rear Position

This is the Grass Zargen left-hand rear mounting socket, a screw-on plastic adapter bracket that anchors the rear of a Zargen drawer system on the left side of the cabinet. Sold in a box of 500, it is a volume component for shops running Zargen-equipped production lines.

Key Features

• Left-hand orientation — made specifically for the left cabinet wall; pair it with the right-hand version to complete a rear-mount installation.
• Rear-mount position — secures the back of the Zargen runner to the cabinet panel, keeping the system aligned through daily use.
• Screw-on mounting — attaches with standard screws directly to the cabinet side, no press-fit boring required.
• White plastic construction — blends with white cabinet interiors and matches the Zargen system's white components.
• 500-unit box quantity — sized for production shops ordering components in volume rather than one-off pairs.

Where This Bracket Belongs in a Zargen Installation

The Zargen system uses rear mounting sockets to support the back end of the drawer runner inside the cabinet. In face-frame and frameless cabinets alike, the rear bracket carries the runner's tail so the front locking device and the rear socket work together to hold the system square. This left-hand bracket handles the left wall; the cabinet side must provide a flat, accessible face for the screw-on attachment. Without a properly seated rear socket, the Zargen runner can drift out of plane under load, so the bracket is a required component of every Zargen drawer installation, not an optional add-on.

Material and Finish

The bracket is molded in white plastic, which keeps weight low and resists the minor moisture variations common inside kitchen and bath cabinetry. The white finish is Zargen-system white, so it reads as a matched component rather than a contrasting one when visible during drawer removal. Plastic construction also means no corrosion concern at the rear panel contact point, even in humid environments. Because this is a system-specific component, it is engineered to the Zargen runner's geometry and is not interchangeable with rear brackets from other Grass series or other brands.

Who Orders This Component

Cabinet shops building white-interior casework with the Zargen drawer system are the primary buyer. A box of 500 supports a production run rather than a single project; shops that specify Zargen throughout a kitchen or multifamily installation will move through rear sockets at the same rate as the runners themselves — two sockets per drawer, one on each side. Renovation contractors sourcing replacement hardware for existing Zargen-equipped cabinets will find the screw-on mounting straightforward without specialized tooling.

Keep the Zargen System Running True

A properly seated rear socket is what holds the Zargen runner in alignment from front to back. Stocking this component in the quantities your production schedule demands means every drawer leaves the shop installed correctly the first time.