Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the left-hand cabinet member from Pro Value's PRO50 series, a 24 inch cream epoxy-coated roller slide component built for shops that buy members in volume and match their hardware to the cabinet interior. One piece arrives; pair it with the right-hand cabinet member and both drawer members from the same PRO50 series to run a single drawer.
The PRO50 series is built for production cabinet shops, refacing crews, and contractors who treat slide hardware as a line item rather than a retail purchase. Ordering members by hand and length means you stock exactly what a run calls for: left-hand cabinet members for the left side of every opening, right-hand members for the right, and drawer members for each box. A 24 inch cabinet member suits cabinets with interior depths that accommodate standard kitchen and bath drawer depths. This member works in both side-mount and bottom-mount configurations, giving installers flexibility when face-frame and frameless boxes come through the same run.
The cream epoxy powder coat is baked onto the steel member, giving it a smooth, low-profile appearance inside the cabinet box. Cream sits between white and almond on the finish spectrum and is a common match for older kitchen interiors, natural-finish plywood boxes, and light-toned melamine. The steel construction carries the load; the epoxy is a finish and color choice, not a structural feature. This is an indoor-only slide — cream epoxy is not a corrosion-resistant finish for damp or exterior environments.
Cabinet shops running cream-interior boxes, remodelers replacing worn members one side at a time, and millwork operations building to a spec that calls for cream hardware are the natural buyers for this SKU. The value-line pricing keeps per-drawer hardware cost low on straightforward kitchen and closet work where the slide's job is simply to carry the drawer reliably. Homeowners replacing a single damaged cabinet member will find the 24 inch length and cream color a practical match for common production-built cabinetry.
One drawer requires four members total: one left-hand cabinet member, one right-hand cabinet member, and two drawer members (one per side). This listing covers the left-hand cabinet member only. All four must come from the PRO50 series — members from other brands or series do not interchange.
The finish is listed as Cream. It is a warm off-white that reads differently from a stark bright white. If you are matching existing hardware, compare the cream color against your cabinet interior before ordering a full production run.
The source data does not confirm a self-closing motion feature for this member. Do not assume self-close behavior; if a closing ramp is required, verify with the series specification before ordering.
This slide requires 1/2 inch of side clearance per side, so build the drawer box 1 inch narrower than the inside cabinet opening width.
Yes, but face-frame installation typically requires rear mounting sockets or brackets to support the back of the slide. Check that the appropriate series-matched hardware is available before specifying for a face-frame job.
Pair this left-hand cream cabinet member with its three matching PRO50 counterparts and the drawer runs on hardware that disappears into the cabinet interior and holds up through years of daily use.
Sold In: 100 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  DSPRO50RBN-R Mfr# EUSKT-1-R | PRO Value PRO50 500-Pack 3-1/2" Rear Mounting Socket, Right Hand, White, EUSKT-1-R | ||||
Sold in: 1 Each |  DSPRO50RBN-L Mfr# EUSKT-1-L | PRO Value PRO50 500-Pack 3-1/2" Rear Mounting Socket, Left Hand, White, EUSKT-1-L |