Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Brockwell pull is a D-handle cabinet pull for wide drawer fronts and tall cabinet doors, mounting on 8-13/16 inch (224 mm) centers.
The 8-13/16 inch center-to-center spacing is sized for the fronts that shorter pulls can look lost on. Wide drawers in a base cabinet, full-height pantry doors, and island fronts in the 24-to-30-inch range all benefit from hardware that spans enough of the front to feel proportional rather than undersized. At this spacing the pull becomes part of the visual composition rather than a detail perched in the middle of a large slab. For a shop or designer running mixed hardware across a kitchen, this is the pull that handles the drawers and doors a 5-inch or 6-inch pull would not carry convincingly.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed texture diffuses light across the surface rather than reflecting a hard point, which keeps the finish consistent under the varying light conditions of a kitchen or bath. Satin Nickel sits in the neutral zone between warm and cool metals, coordinating easily with stainless appliances and chrome plumbing fixtures without demanding an exact match. The D-handle form runs the grip between two end returns, so the bar presents a flat face at 1/2 inch wide rather than a round cross-section.
Cabinet shops building furniture-style kitchens with oversized drawer banks, designers specifying hardware for islands and pantry walls, and homeowners replacing hardware on wide existing drawers all land on a spacing in this range. The Brockwell collection is a transitional series, meaning it works across both flat-slab contemporary cabinetry and frame-and-panel traditional door styles without pulling hard in either direction. Contractors doing a whole-kitchen hardware replacement on a mid-to-large layout will find this center-to-center covers the fronts that anchor the room.
The 8-13/16 inch (224 mm) figure is the drilling dimension, measured between the centers of the two mounting holes. The overall length is 9-1/8 inches (232 mm), which is the full end-to-end size of the pull. When replacing existing hardware, match the center-to-center measurement to your existing holes.
A common design practice is to size a pull to roughly one-third of the front's width. At 9-1/8 inches overall, this pull is a natural fit for fronts in the 24-to-30-inch range. That said, sizing is a design preference rather than a hard requirement.
Satin Nickel is a silver-tone finish that reads close to brushed stainless in most kitchen settings. An exact match cannot be guaranteed across manufacturers, but it is one of the finishes most commonly paired with stainless appliances.
Yes. The Brockwell collection includes companion knobs and additional pull sizes in the same design language and Brushed Satin Nickel finish, which is the practical way to run pulls on drawers and knobs on doors.
Choose this pull when the drawer or door width calls for a center-to-center measurement in the 224 mm range and the finish program is Brushed Satin Nickel.
Sold In: 1 Each