Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune 2646-S is a stainless steel bar pull from the 26 Series, sized at 3-3/4 inch (96 mm) center-to-center and built for cabinet doors and drawer fronts where a clean, linear grip belongs.
The 96 mm center-to-center spacing is the single most prevalent hole pattern in cabinet manufacturing, which means this pull is the right call for any shop or installer working with standard face-frame or frameless production cabinetry. On a replacement job it matches existing holes without any additional drilling. On a new build it aligns with most standard hinge and hardware boring programs, which keeps layout straightforward. The 6-5/16 inch overall length positions the pull visually across a mid-width drawer or a door stile without overhanging the edges, giving it a finished look on fronts from roughly 12 to 24 inches wide.
This pull is constructed from stainless steel and carries a Stainless Steel finish, meaning the surface color and the base material are the same throughout. That matters in a working kitchen or a high-use application: there is no plating to wear through at contact points, and the finish does not shift color at the edges or in the bore holes where the fasteners seat. The surface carries a consistent Silver Tone across the bar and posts, which reads as neutral in most hardware programs and coordinates readily with stainless appliances, sinks, and fixtures already in the room.
Cabinet shops running production on standard 96 mm boring centers will find this pull slots into their existing workflow without a layout change. Designers specifying a contemporary or transitional kitchen where all the hardware should read as a single clean material will appreciate the consistent stainless surface. Contractors replacing hardware on an existing cabinet bank drilled to 3-3/4 inch centers can swap these in directly. The bar profile and neutral finish also make this a practical choice for commercial millwork, breakroom cabinetry, and built-ins where hardware is expected to hold up over a long service life without looking worn.
The Material Type is stainless steel, so the construction and the finish are the same material throughout, not a stainless coating over a zinc or aluminum core.
Yes. At 3-3/4 inch (96 mm) center-to-center this pull mounts directly onto that hole pattern with no re-drilling.
The Sugatsune 26 Series is available at multiple center-to-center spacings, so companion pulls in the same stainless finish and bar profile can be specified across different drawer and door widths in one project.
The pull projects 1-3/8 inch (35 mm) from the face of the door or drawer front to the back of the bar, which gives comfortable finger room for a full-hand grip.
For any project running 96 mm centers, this Sugatsune 26 Series pull delivers a straightforward fit, a material that holds its appearance, and a bar profile that works across contemporary and transitional cabinetry without demanding attention.