Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-6 Series 14 inch full-extension ball bearing drawer slide is built from 304 stainless steel for installations where a zinc-plated cabinet slide would corrode, stain, or fail. This is a side-mount, non-handed slide rated 130 lb per pair, with standard free-sliding motion and complete drawer access at full open.
Most cabinet environments are dry enough for a zinc-finished slide. The ESR-6 is built for the ones that are not. Commercial kitchens, food processing lines, marine cabinetry, lab casework, outdoor pavilion storage, and coastal installations all expose hardware to moisture, cleaning chemicals, or salt air that attacks zinc over time. In those settings, 304 stainless steel is not an upgrade — it is the correct material choice. At 14 inches, this slide suits compact drawers in utility stations, prep counters, and equipment cabinets where full drawer access still matters in a tight space.
The ESR-6 is a telescopic three-member ball bearing slide: the intermediate member is what lets the drawer travel the full slide length and clear the cabinet opening. Ball bearings run in formed stainless raceways for smooth, consistent pull under load. The stainless steel finish is the material itself, not a coating applied over a different substrate — there is no zinc underlayer to undercut, no epoxy to chip, and no surface treatment to re-specify for a wet-rated install. This is a standard-motion slide with no built-in closing mechanism, which keeps the design simple and service-friendly in environments where a damper or spring would be exposed to the same conditions as the hardware.
The ESR-6-14 fits buyers who need a verified stainless material spec and a load rating above the standard 100 lb cabinet class. Commercial kitchen designers specifying drawer hardware under health code scrutiny, marine cabinet shops building below-deck storage, lab furniture fabricators, and contractors outfitting outdoor kitchens all reach for a slide like this when the spec sheet calls for stainless. It is equally useful to a serious woodworker building a shop cabinet that will live near a sink or in an unheated space with humidity swings. If the installation is dry and indoors, a zinc-finished slide at lower cost does the same job — choose stainless when the environment demands it.
The ESR-6 is built from 304 stainless steel — the material, not a finish applied over another substrate. 304 is the standard austenitic alloy for food service and wet environments.
Side clearance for the ESR-6 series is not stated in the available product data. Contact Sugatsune or check the ESR-6 installation sheet before sizing the drawer box — standard side-mount ball bearing slides typically need 1/2 inch per side, but confirm the ESR-6's own specification.
The 130 lb rating is per pair of slides — both slides working together. Do not double it by counting each slide separately.
Side-mount slides installed in face-frame cabinets need rear support — either a rear mounting bracket or a slide version with a face-frame front-mount option. Check whether the ESR-6 series has a compatible rear bracket before ordering for face-frame construction.
This ESR-6-14 is a standard-motion slide with no closing mechanism. If soft-close is needed, check whether Sugatsune offers a soft-close variant in the ESR-6 series or a compatible add-on damper.
When the installation calls for stainless — because the spec sheet requires it, the environment demands it, or a zinc finish simply would not last — the ESR-6 delivers full extension and a 130 lb per pair rating in the material that belongs there.
