Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune SN-95/BL is an L-shaped edge pull in Matte Black, mounting on 2-9/16 inch (65 mm) centers. At the top of the SN Edge Series center-to-center range, it is sized for wider drawer fronts and cabinet doors where a shorter pull would look undersized or feel under-gripped.
Spacing is a proportion decision as much as a mechanical one. A 65 mm center-to-center pull occupies more of a drawer front than the 30 mm, 45 mm, 46 mm, or 57 mm options in the same series, which suits mid-width and wider fronts where a smaller pull can look lost. Drawers in the 12 to 18 inch range, pantry doors, and lower cabinet doors where a confident grip matters are the natural fits for this spacing. The L-shaped cross-section keeps the pull tucked tight to the surface, so even at this size the hardware does not impose on the face of the door.
This pull is constructed from 304 stainless steel, a grade chosen for its corrosion resistance and its ability to hold a consistent surface finish over years of daily contact. The Matte Black finish gives the steel a low-sheen, non-reflective surface that holds its tone under kitchen, bathroom, and laundry room lighting without picking up the glare a polished finish would. Stainless steel also resists the minor surface deformation that plated zinc can show over time at contact points, which is a practical advantage on hardware that gets handled every day.
This pull suits cabinet shops, designers, and contractors specifying a complete hardware program across a kitchen, bath, or utility space. Because the SN Edge Series covers five center-to-center sizes in the same profile, finish, and material, a project can run pulls sized to every drawer and door width from a single coordinated family. The 65 mm spacing is the series anchor for fronts where the smaller sizes would read as too delicate. It also works well in commercial and hospitality millwork where consistent hardware language across a large installation is a specification requirement.
The 65 mm (2-9/16 in) pull is the largest in the SN Edge Series and is proportioned for wider fronts. The 57 mm (2-1/4 in) sits one step below. Both share the same L-shaped profile, 304 stainless steel construction, and Matte Black finish.
304 stainless steel is the base material the pull is made from. Matte Black is the surface finish applied over it. The two are separate: the steel is structural and the finish is cosmetic.
The projection is 1-1/2 inches (38 mm), measured from the mounting surface to the back of the grip.
Yes. All five sizes in the SN Edge Series share the same profile geometry, finish, and material, so they coordinate visually across a single installation even when different drawer widths call for different spacings.
When the rest of the SN Edge Series sizes are too short for the drawer or door in front of you, this 65 mm pull closes the gap without changing the hardware family.
