Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune SNB-50/BB is a solid brass edge pull from the SNB series, designed for cabinet doors and narrow drawer fronts where a 1-3/16 inch (30 mm) center-to-center hole pattern is required.
A 1-3/16 inch center-to-center is a narrow hole pattern. It suits small upper cabinet doors, overlay doors on frameless cabinetry, thin drawer fronts, and anywhere the door or front width leaves little room for a wider-spaced two-hole pull. When replacing existing hardware drilled to this spacing, the 30 mm pattern is a direct match. Because the hole spacing is tight, the pull reads as a single crisp grip point rather than a spread bar, which keeps narrow fronts looking proportionate.
This pull is made from solid brass rather than plated zinc, which is the less common base material across this catalog. Solid brass has more mass in hand and develops a surface character over time that plated finishes do not. The Bright Brass finish gives it a warm, polished gold tone: reflective and clean rather than brushed or antiqued. On painted cabinetry it reads as a deliberate accent. On natural wood it joins the warm register of the wood grain without competing with it.
This is a practical choice for cabinet shops, designers, and renovation contractors specifying hardware on narrowly spaced fronts where solid brass construction matters. The L profile is an edge pull by design, so it suits applications where the grip runs at or near the edge of the door rather than across the face. It works on small upper doors in a kitchen, on medicine cabinet fronts, on compact drawer banks in a bath vanity, and on frameless cabinet programs where tight hole spacing is common. Because it belongs to the SNB series, coordinating pieces in the same collection carry the same design language and finish.
Standard bar pulls in this catalog run from 3 inches (76 mm) up to 18 inches (457 mm) between centers. At 1-3/16 inches (30 mm), this pull's hole pattern is much tighter, suited to small fronts and edge-mount applications rather than wide drawers.
The Material Type is brass, meaning the pull is brass construction, not a brass-toned finish over zinc. That is less common in this category and accounts for the difference in feel and weight.
The projection is 1-1/2 inches (38 mm) from the mounting face to the back of the grip.
Yes. The L profile works on a door edge or face depending on how it is mounted. It is a common choice for small upper cabinet doors and overlay door programs.
When the front is too narrow for a standard bar pull and the specification calls for solid brass, this SNB series edge pull covers both requirements in one compact fitting.
