Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune SND-50/M is a stainless steel edge pull in the SND series, designed for cabinet doors and drawer fronts where the pull mounts at or near the edge and the hardware should stay visually minimal.
At 1-3/16 inches between holes, this is the tightest center-to-center spacing in the SND line. That matters in a few specific situations: a frameless cabinet door with a narrow stile that will not accommodate a wider hole pattern, a thin drawer front on a furniture piece or media unit, or an edge-pull position where the drill layout is constrained by the front's width rather than the designer's preference. When the front is narrow enough that the standard spacing options leave one hole landing in empty space or in the door's edge relief, the 30 mm spacing is the one that fits. It is also the natural choice for smaller drawers in a run where visual scale calls for hardware proportionate to the front, not oversized against it.
The SND-50/M is machined from 304 stainless steel and finished to a mirror polish. Stainless steel is the base material, not a coating applied over a different substrate, which means the corrosion resistance is intrinsic to the part rather than dependent on the surface staying intact. The mirror finish is a bright, highly reflective surface that reads almost chrome-like under direct light. It catches and amplifies the light sources around it, which suits a contemporary kitchen or bath where the hardware is meant to be noticed. Mirror-polished stainless also shows fingerprints readily and wipes clean just as readily. On an edge pull, the grip contact area is on the inner face of the L rather than the polished outer face, so the visible surface stays cleaner in daily use than it would on a conventional bar pull of the same finish.
This pull suits cabinet shops and designers working on handleless-adjacent projects: contemporary kitchens, media walls, bathroom vanities, and furniture pieces where the pull is integrated into the door edge rather than applied to its face. The Sugatsune SND series is a professional specification line, and the 30 mm variant is the one specifiers reach for when the door program includes narrow stiles or the layout requires a tighter hole pattern than the rest of the SND family provides. Because the series spans multiple sizes, it is practical to run the 30 mm pull on smaller fronts and a larger SND spacing on wider ones, keeping finish and profile consistent across the whole installation.
Measure the distance between the centers of your existing holes. If they fall at 1-3/16 inches (30 mm), this pull drops onto them directly. The 30 mm spacing is less common than 96 mm or 128 mm on conventional pulls, so confirm the measurement before ordering.
It is an edge pull with an L-shaped profile. It wraps the door or drawer edge, with the grip extending behind the front rather than projecting from the face.
304 is a common austenitic stainless steel grade with good corrosion resistance for interior applications. It is the base material of the pull, not a surface coating.
The SND series is available in multiple center-to-center sizes. Pulls within the series share the same profile and Mirror finish, so mixing sizes across different door widths is a common approach for maintaining visual consistency.
When a narrow stile or a constrained layout rules out the larger SND spacings, the 30 mm center-to-center version delivers the same mirror-polished stainless edge pull in the footprint the front actually has room for.
