Formwood Cherry Melamine Edgebanding gives cabinet and furniture projects a cherry-look edge that visually ties into cherry-toned surfaces, so cut panel edges present as finished rather than raw. This edgebanding is 7/8 inch wide, which covers the thickness of standard sheet goods with a bit of overhang for flush trimming, helping installers dial in tight, straight edge lines. The 250 foot length supports multiple cabinets or a full small run from one continuous roll, which reduces splice points along edges. The material is melamine, so the face presents a consistent cherry appearance along the full length. The edgebanding is pre-glued, so the adhesive is already on the back and ready for activation, which supports a straightforward edging workflow using typical heat-based application methods.
This Formwood Cherry Melamine Edgebanding uses a pre-glued backing, so the adhesive layer is already bonded to the melamine strip and simply needs activation during application. The 7/8 inch width gives extra material past the edge of common panels, leaving room to trim both faces back flush after bonding for a square, finished edge line. With 250 feet available on the roll, installers can set up for longer continuous runs along cabinet sides, shelves, or doors without returning to change material, which supports consistent speed and edge appearance across a project.
Formwood Cherry Melamine Edgebanding 7/8 inch W x 250 feet Pre-Glued is suited to edging cherry-toned panel products where a melamine-faced cherry appearance is required on exposed edges. The 7/8 inch width allows use on typical engineered wood panels while leaving sufficient overhang for trimming on both sides, helping edges sit tight to door, drawer, and casework faces. The 250 foot length means one roll can handle edging across multiple cabinets, closet sections, or furniture components, which keeps the cherry edge color consistent from part to part. As melamine edge banding, the product pairs with melamine-faced assemblies where a uniform cherry look around the perimeter is desired.
The pre-glued construction on this Formwood melamine edge banding places the adhesive directly on the back of the strip, so each length cut from the roll already carries glue in a consistent layer, which assists in even bonding along straight cabinet edges. The cherry melamine surface is factory-applied, providing a consistent color and pattern run over the full 250 feet, so sequential parts share the same cherry appearance at the edge. The defined manufacturer part number PGCHERRY7/8 gives shops a precise reference when specifying or reordering the same cherry melamine edgebanding, helping maintain continuity on follow-up work or matching future repair pieces to existing installations.
Formwood Cherry Melamine Edgebanding is 7/8 inch wide, giving enough coverage to span typical panel thicknesses while leaving material to trim back for a clean finished edge.
The Formwood PGCHERRY7/8 cherry melamine edgebanding roll is 250 feet long, supporting edging across multiple cabinets or furniture pieces from a single continuous length.
This product is melamine edgebanding, providing a cherry-look surface along the edge that complements cherry-toned melamine or similar decorative panels in casework.
Formwood Cherry Melamine Edgebanding is pre-glued, so the adhesive is factory-applied to the back, ready for activation during the edging process.
The 7/8 inch width extends slightly past common panel faces, allowing installers to trim both sides back flush, which supports straight, tight edge lines on finished parts.
The manufacturer part number is PGCHERRY7/8, giving shops a clear identifier when specifying or reordering this Formwood cherry melamine edgebanding.
Formwood Cherry Melamine Edgebanding 7/8 inch W x 250 feet Pre-Glued from Wurth Baer Supply gives shops a defined cherry-look melamine edge solution with factory-applied adhesive, a 7/8 inch trimming-friendly width, and a 250 foot roll length suitable for multi-part cabinet and furniture runs.
Sold In: 1 Roll