Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series tambour door is a solid alder, flat-edge panel sized to cover a full 36-inch-wide opening across a 60-inch travel length, ready to roll into an appliance garage track and finish to match the surrounding cabinetry.
An appliance garage with a wide or tall opening needs a panel sized to cover the span without a gap or a seam. At 60 inches of travel and 36 inches across, this door suits garage installations that serve a countertop appliance station, a breakfast nook area, or any run where the opening is wider than a standard 24-inch or 47-inch panel can close. The flat edge means there is no decorative routing between the slats, which keeps the closed face simple and lets the wood grain carry the visual. The tambour track and any mounting hardware are sold separately; this SKU is the door panel only.
Alder is a fine-grained hardwood that mills cleanly and accepts finish predictably, making it a practical choice when the door needs to blend into painted or stained cabinetry rather than stand out as a feature. Because the panel ships unfinished, the finish applied on-site determines the final look. That means a shop or installer can match an existing stain, hit a custom paint color, or apply a clear coat for a natural wood tone. The slats are solid wood throughout, not a veneer over a substrate, so the surface can be sanded and refinished if the application calls for it.
Cabinet shops building custom appliance garages are the primary buyer, particularly when the garage is sized for a wider countertop zone and requires a panel that travels the full span. Designers specifying a kitchen with concealed appliance storage will reach for the flat edge when the cabinetry style leans contemporary or transitional and a routed profile would read as too traditional. The unfinished state also suits a project where the final finish has not been determined at the time the panel is ordered, since the shop can hold it until the paint or stain decision is made and finish it alongside the cabinet doors for a consistent match.
No. This is the door panel only. The tambour track, guide hardware, and any mounting components are sold separately and must be matched to the specific garage opening and track system being used.
The slats are solid alder throughout, not a veneer. That allows the surface to be sanded and finished in the field without concern about cutting through a face layer.
The 60-inch measurement is the panel length, which corresponds to the travel distance the door covers as it rolls along the track. The 36-inch measurement is the panel width, which sets the opening it closes across.
Trimming a tambour panel requires care to avoid separating the slats from the backing. For a smaller opening, a panel sized closer to that dimension is the better starting point.
When the opening is too wide for a standard-length panel and the finish needs to be matched on-site, this solid alder flat-edge door delivers the coverage and the finishing flexibility the job requires.
Sold In: 1 Each