Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Amerock #6 x 5/8-inch oval head screw in Satin Nickel is a finish-matched installation screw designed to mount decorative cabinet hardware where the fastener will remain visible after installation. The dome top sits slightly proud of the surface, complementing knobs, pulls, and backplates finished in Satin Nickel.
Oval head screws are chosen when the fastener is meant to be seen. The domed top rises slightly above the surface after seating in a countersunk hole, creating a rounded, finished look that blends with surrounding hardware rather than disappearing into it. This makes these screws a natural pairing for decorative Amerock pieces such as backplates, escutcheons, and surface-mounted hinges where a flush-head screw would feel out of place visually. The 5/8-inch length is well suited to the shallow engagement typical of trim hardware and face-mounted cabinet accessories.
The Satin Nickel finish on these screws is the same surface tone carried across Amerock's Satin Nickel hardware line, so the fastener head reads as part of the hardware rather than a separate element. Steel construction handles the light clamping loads of decorative interior hardware. These screws are for indoor cabinetry and furniture; for exterior or high-humidity environments, a corrosion-resistant fastener would be the appropriate choice.
Designers specifying Amerock Satin Nickel hardware throughout a kitchen or bath can use these screws to keep every visible fastener in the same finish family. Cabinet shops and installers working with surface-mounted hardware benefit from having the correct finish-matched screw on hand so the completed installation looks intentional. Homeowners replacing existing hardware will find that these screws replace mismatched or worn fasteners without drawing attention to the screw itself.
A flat head countersinks flush or below the surface and largely disappears. An oval head leaves a small, rounded dome above the surface, which is appropriate when the screw is part of the visible hardware assembly, such as on a backplate or decorative escutcheon where the head is expected to show.
Yes. These screws are part of the Amerock Satin Nickel line and are intended to coordinate with other hardware in that finish. Using a matched screw avoids the visual mismatch of a chrome or brass head against a Satin Nickel backplate or plate hinge.
Yes. The oval head has a conical underside that seats in a countersink, with the dome rising above the surface. Without a countersink, the head will sit proud on its full taper and will not seat cleanly.
These are indoor screws. The steel construction with Satin Nickel finish is appropriate for dry interior cabinetry. For outdoor or high-moisture installations, use a fastener rated for exterior or corrosive environments.
A standard #2 Phillips bit, the most common driver bit in any shop or toolbox.
When the screw head is visible, finish matters as much as function. These Amerock Satin Nickel oval head screws keep the complete hardware installation looking cohesive from the pull to the last fastener.