Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National molding is a solid maple crown molding in a large crown profile, built for cabinet programs where the ceiling height and the run length reward a wide, substantial trim line at the top.
Crown molding at the top of a cabinet run does two things: it closes the transition to the ceiling and it sets the visual weight of the entire installation. A large crown profile earns its place where the room has the height to absorb it. Full-height cabinetry reaching 84 or 96 inches, vaulted ceilings, or any run where the top of the cabinet lands well below the ceiling line are the situations where a 4-1/8 inch face reads as deliberate and finished rather than oversized. In a standard eight-foot room where the cabinets stop close to the ceiling, the same profile competes with the architecture instead of completing it. The large crown is a proportion decision before it is a style one.
Maple is a hard, closed-grain species that machines cleanly and holds fine detail in a profiled edge without tear-out or fuzz. It accepts paint evenly and takes stain with a consistent, low-variation result across its face. Because it arrives unfinished, the finishing sequence is the shop's or the installer's to set, which makes it straightforward to match existing cabinetry or a specified finish system. Maple does not shift in color over time the way cherry does, so new crown installed alongside a long-standing maple program is working from the same baseline.
Cabinet shops specifying a large crown for a high-ceiling kitchen or a floor-to-ceiling library wall, designers finishing a traditional or transitional program where the top detail carries real visual weight, and contractors matching an existing Omega National maple run will all find the profile and species here. The 96 inch length is the unit to estimate in: measure the total linear footage of the crown run and order in whole lengths.
No. This is a plain large crown profile without any rope or decorative twist element. The two are different profiles and are not interchangeable within a run.
Maple's closed grain can resist penetrating stains unevenly at deep tones. A pre-conditioner or toner base helps control blotching when specifying a very dark finish.
The molding is 4-1/8 inches wide at 13/16 inch depth. The visible face width once the molding is seated against both the wall and the cabinet top will depend on your ceiling height and the cabinet height, since crown sits at an angle to both planes.
It is unfinished solid wood. No primer, stain, or topcoat is applied at the factory.
Choose this large crown when the installation has the height to carry a 4-1/8 inch face and you want a solid maple profile that finishes to the program's spec.
Sold In: 1 Each