Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #8 x 1-1/4" flat head assembly screw is sized for face-frame joinery, cabinet carcass assembly, and panel work where 3/4-inch stock is the material. The coarse thread bites into softwood, plywood, and engineered panels, while the Type 17 Auger point and combo drive keep production moving at the bench or on the job site.
At 1-1/4", this screw is at home in the joints that define cabinet production: pocket-hole rails to stiles, face-frame attachment to the cabinet box, and panel-to-panel connections in softwood and engineered sheet goods. The length gives adequate thread engagement through the joint without over-penetrating the back panel or blowing through a narrow stile. Coarse thread is well matched here — softwood, plywood, MDF, melamine, and particleboard all grip a coarse thread better than a fine one, and the thread pattern pulls the joint closed as the screw seats.
The black finish is a practical choice for cabinet interiors, dark-stained frames, and panel applications where a zinc or silver head draws the eye. It is an interior finish suited to dry, climate-controlled conditions. The flat head countersinks flush with or just below the surface, and the underhead nibs do the countersink work for you — they mill the seat as the screw is driven so the head lands clean without a separate step. That matters in production work where a pre-countersink operation on every hole adds up fast.
Nine thousand screws per box is a production quantity. This SKU fits the shop that builds cabinets week after week and wants a reliable, single-source assembly screw stocked in the back rather than picked up in small boxes. The combo drive recess keeps things flexible — a #2 square bit for the speed and bit retention it delivers when a correctly sized bit is in the gun, or a #2 Phillips when that is what is on hand. Both engage the same recess. The Type 17 Auger point handles softwood framing stock and engineered panels alike, so the same screw works across the box sides, the face frame, and the drawer-box material without a bin change.
A 1-1/4" screw driven at the angle of a pocket-hole joint into 3/4-inch stock reaches full thread engagement without the tip breaking through the face of the receiving piece. It is the standard sizing for that joint geometry in softwood and engineered panels.
The same recess accepts either a #2 Phillips bit or a #2 square bit. You do not need a different screw to switch between drivers.
The Type 17 Auger point has a flute near the tip that cuts and clears wood fibers as the screw enters. This reduces the torque needed to start the screw and lowers the risk of splitting, particularly in denser softwoods and at pocket-hole entry angles.
This screw carries a coarse thread, which is best matched to softwood, plywood, MDF, melamine, and particleboard. Hardwood face frames in maple, oak, or cherry call for a fine-thread screw to prevent splitting and maximize holding power in dense grain.
The nibs mill a clean countersink seat as the head drives down, so the head lands flush without a separate countersink operation. This is especially useful in production work where pre-countersinking every hole adds cycle time.
No. The black finish on this screw is for interior, dry applications. For exterior work or treated lumber, choose a screw with a corrosion-rated coating.
When the bench is running 3/4-inch cabinet stock and the bin needs to stay full, this Würth #8 x 1-1/4" flat head assembly screw delivers the right length, thread, point, and drive combination in a quantity that keeps pace with production.
Sold In: 9000 Each
