Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #8 x 5/8" pan head hinge and drawer slide installation screw is designed for mounting European hinges, drawer slides, and cabinet hardware to panels where only a shallow bite is available. The 5/8" length keeps the screw well within the thickness of a standard 3/4" cabinet panel, making it the right choice when a longer screw would blow through the face.
Hardware mounting in frameless and face-frame cabinetry often demands a screw that stays inside the panel. Hinge mounting plates, drawer slide brackets, and other hardware attach to the interior faces of 3/4" cabinet sides and floor panels. A 5/8" screw sits comfortably within that thickness, leaving a safe margin from the finished exterior surface. It is the length to reach for when installing hinges directly into a panel side, securing slide brackets near the bottom of a cabinet box, or fastening any hardware whose mounting holes align with shallow stock.
The pan head profile provides a flat bearing surface that seats squarely against the mounting plates on European hinges and drawer slides. No countersink is needed and no head will stand proud once the hardware is seated against the panel face. The #2 Phillips drive is the standard for installation work, compatible with the corded drills, cordless drivers, and bit sets most shops and crews already carry. The zinc finish is appropriate for the dry, indoor conditions inside a finished cabinet.
Cabinet shops and installers driving dozens of hinges and slides per day benefit most from a screw this consistent. The Type 17 auger point starts without wandering in pre-bored hinge cup holes and panel faces, and the coarse thread pulls the bracket tight against the panel surface in a single pass. Packed 15,000 to the box, this screw is sized for the demands of production shops running full kitchen and bath sets, as well as installers building inventory before a large commercial or multi-unit project.
A 5/8" length keeps the fastener well within a 3/4" panel, leaving a safe margin from the finished exterior face. A longer screw risks breaking through the show surface of a cabinet side or door panel.
No. The pan head is designed to bear flat against the surface of a mounting plate or bracket. The hardware's mounting hole accepts the head without any countersink preparation.
The auger flute near the tip clears material as the screw enters, lowering the torque needed to start and reducing the chance of the screw wandering off position, especially when driving into a pre-bored mounting hole.
Yes. The 5/8" length and pan head profile work in both construction types wherever hinges or drawer slides mount to a panel face or interior frame member of standard thickness.
This screw is intended for dry interior cabinetry. Zinc plating provides standard protection in that environment but is not rated for sustained moisture exposure or outdoor use.
When every hinge and slide needs to seat the same way across a full run of cabinets, the right screw makes that repeatable. The 5/8" pan head Phillips installation screw gives production shops and site crews a dependable, shallow-reach fastener stocked in the quantity the work actually demands.
Sold In: 15000 Each
