Würth #8 x 3/4" Washer Head Hinge and Drawer Slide Installation Screw Combo Drive - Type 17 Auger Point Coarse Thread Zinc, 3670000219961 1000 - 6000/Box

Zinc Finish And A Clean Hardware Fit For Every Install

The Würth #8 x 3/4" Hinge and Drawer Slide Installation Screw is a purpose-built fastener for mounting European cup hinges, drawer slides, and cabinet hardware to wood panels. The zinc finish gives the screw a clean, neutral appearance that sits unobtrusively behind hardware plates, and the washer head, combo drive, and Type 17 Auger point work together to make hardware installs fast and consistent across a full cabinet run.

Key Features

• Zinc finish provides a clean, hardware-neutral look that does not call attention to the fastener behind the mounting plate.
• Washer head distributes clamping load across the hardware mounting plate without pulling through or dimpling the substrate.
• Combo drive accepts a #2 Phillips or a #2 square bit in the same recess, so the screw works with whatever driver is on the bench.
• Type 17 Auger point starts quickly and clears material as it drives, reducing the force needed to seat each screw in cabinet panels.
• Coarse thread for wood panels grips plywood, MDF, and particleboard cabinet substrates reliably at this length.
• Packed 1000 to the box, sized for a full shop run of hinge and slide installations without running short mid-job.

Built For Hardware Mounting On Wood Cabinet Panels

This screw is sized and shaped for the work of attaching European-style hinges, side-mount drawer slides, and related cabinet hardware to the interior panels of a cabinet box. At 3/4 inch, it seats securely into 3/4-inch plywood, MDF, or particleboard panels without punching through the back face. The washer head spans the countersunk holes and elongated slots in hardware mounting plates, holding them flat and flush without concentrated stress around the fastener hole. The coarse thread pulls the hardware plate tight against the panel face with each drive.

Zinc Finish In The Context Of A Cabinet Interior

Cabinet hardware installs involve dozens of screw heads visible inside a finished box. The zinc finish on this screw keeps those heads looking intentional rather than incidental. It is a consistent, clean metal tone that pairs quietly with the chrome, nickel, and steel finishes common on European hinges and drawer slides, without the warm cast of a lubricated or oiled finish. For shops building painted or light-finished interiors, zinc is often the first choice precisely because it disappears behind the hardware it holds.

Where This Screw Fits Best

Cabinet shops and installers who work through boxes of hinge and slide screws on every job will find this pack size practical for a full kitchen or bath cabinet run. The combo drive is well suited to shops where Phillips drivers are already in rotation alongside square-drive bits, since the same screw works with both without swapping inventory. Frameless cabinet construction benefits from this screw's geometry particularly, because the washer head is matched to the pre-bored mounting holes in European hardware plates rather than requiring a separate countersink step. The 1000-piece box carries a crew through a sizeable install without the interruption of reordering mid-project.

Common Questions

The Right Fastener Behind Every Hardware Plate

When every hinge and slide needs to seat consistently and the interior of the cabinet needs to look finished, this zinc screw gives a shop the right head profile, the right drive flexibility, and the right quantity to work through a full run without slowing down.