Würth #8 x 3/4" Truss Head Hinge and Drawer Slide Installation Screw Combo Drive - Type 17 Auger Point Coarse Thread Zinc, 367000024596112000 - 12000/Box

Short Length, Solid Fit for Hinge and Drawer Slide Work

This Würth #8 x 3/4-inch truss head screw is built for mounting European cup hinges and drawer slides to cabinet panels. The 3/4-inch length is sized to seat fully through a hardware mounting plate and grip the panel without over-penetrating, making it a precise fit for the standard hinge and slide installations found in production cabinetry and finish carpentry.

Key Features

• 3/4-inch length sized to seat hardware mounting plates against cabinet panels without punching through.
• Truss head with a wide, low-profile bearing surface that bridges hardware mounting slots and prevents pull-through.
• Combo drive accepts either a #2 Phillips or a #2 square bit in the same recess, giving you flexibility with whatever driver is in hand.
• Type 17 Auger point cuts into the panel cleanly to reduce driving torque and limit splitting near the screw hole.
• Coarse thread provides strong pull-out resistance in plywood, particleboard, and solid-wood cabinet panels.
• Zinc finish for standard interior cabinet applications.

Where the 3/4-Inch Length Does Its Job

Most European cup hinges and side-mount drawer slides are secured with short screws driven into the face of a 3/4-inch panel. A longer screw risks breaking through the opposite face or into a finished interior surface; a shorter one may not grip enough material to hold hardware under repeated use. The 3/4-inch length hits the practical middle: the screw engages a meaningful thread depth in the panel while the truss head clamps the mounting plate firmly in place. It works with equal reliability in plywood, melamine-faced particleboard, and solid-wood face-frame stock.

Truss Head and Combo Drive in Practice

Hinge and drawer slide mounting plates often have oversized or slotted holes to allow adjustment. The truss head's wide, flat bearing surface spans those slots and distributes clamping load evenly, which keeps the hardware from rocking after final tightening. The combo drive recess accepts a #2 Phillips or a #2 square bit. The square recess is designed to hold the screw on a correctly sized bit for controlled one-handed placement in tight cabinet interiors, and the Phillips option remains available when that is the bit already in the gun.

The Right Screw for Cabinet Shops and Installation Crews

At 12,000 screws per box, this SKU is matched to shops and crews that install hardware in volume. A production cabinet shop cycling through dozens of cases per week, an installer setting hardware on a large multi-unit project, or a millwork team stocking a service van will find this pack size reduces replenishment interruptions. The zinc finish suits the indoor, climate-controlled environments where finished cabinetry lives.

Common Questions

Hardware Goes In Right the First Time

When the length, head, and drive are matched to the hardware and the panel, installation moves without interruption. This 3/4-inch truss head screw is that match for standard hinge and drawer slide work in production and finish cabinetry.