Nickel Concealed Hinge With a Wider Swing for Full Overlay Doors

This Blum CLIP top hinge hangs full overlay doors on frameless and face-frame cabinets, with INSERTA toolless mounting and a self-close spring, in a nickel finish and at a 107 degree opening angle.

Key Features

• 107 degree opening gives a slightly wider swing than the standard 110 degree hinge, suited to cabinets where door travel needs to stop just short of flat.
• Self-close spring pulls the door shut over the last few degrees so it latches on its own.
• Full overlay straight arm positions the door to cover nearly the entire cabinet side, leaving a narrow reveal.
• INSERTA toolless plate mounting presses the base plate into pre-drilled 5mm system holes without screws for fast installation.
• Three-way adjustment at the arm lets height, side, and depth be dialed in after mounting.
• Nickel finish on steel integrates with standard hardware finishes across a wide range of cabinet styles.

A Slightly Wider Swing on Full Overlay Doors

The 107 degree opening sets this hinge apart from the more common 110 degree version. In practice, that difference is most useful where a wall, an appliance, or an adjacent cabinet sits close enough to the door arc that stopping a few degrees earlier is the cleaner fit. The door still swings wide enough for easy access, and the full overlay geometry keeps the door covering nearly the whole cabinet side with only a narrow gap at the reveal. The 35mm cup bores into the back of the door, and the arm clips to a base plate mounted on the cabinet. That plate is a separate purchase and must be a Blum plate matched to this series.

Steel Build, Nickel Finish, Spring-Close Function

The hinge is plated steel in a nickel finish, consistent with the hardware finishes used across most residential and light commercial projects. The closing mechanism is self-close: once the door is pushed to within a few degrees of closed, the spring takes over and pulls it shut. This is a spring-pull close, not a damped close. If a cushioned, quiet landing is the requirement, the BLUMOTION soft-close version of this series addresses that instead.

Where This Hinge Belongs

This hinge fits frameless and face-frame cabinets running standard 16 to 22mm doors. INSERTA mounting is the fastest path on a production cabinet with pre-drilled 5mm system holes, the kind found in most modern frameless boxes and in face-frame cabinets built to the 32mm system. Without those holes in the cabinet side, the screw-on plate version is the right substitute. Cabinet shops running volume orders, contractors stocking for installs, and designers specifying full overlay with a self-close spring will all find this a reliable, finish-coordinated choice. For doors thicker than 22mm, a thick-door hinge is the correct selection.

Common Questions

Full Overlay Doors That Close Themselves, Finished in Nickel

Specify this hinge when the job calls for full overlay doors with a self-close spring, INSERTA-speed plate mounting, and a nickel finish that coordinates with the rest of the hardware on the run.