Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #5 x 13mm Euro Screw is a flat head, Phillips drive fastener built for mounting European cup hinges, drawer slides, and other 32mm system hardware into pre-bored cabinet panels. With a nickel finish, coarse thread, and 7.5mm head, it is listed for use with Grass hardware and fits the line-bored hole patterns standard across European-style cabinetry.
Euro screws work inside a defined system. The 5mm gauge and 13mm length are matched to the pre-bored hole patterns used in European-style frameless cabinetry, where hinge plates, drawer slide clips, and shelf hardware mount through short, precise screws into the panel face or edge. The blunt point means the screw threads into the hole rather than piercing new material, so correct hole diameter matters. At 13mm, the screw seats the mounting plate without over-penetrating a standard 3/4-inch (19mm) cabinet side or back panel. This screw is specifically listed for Grass hardware, making it a direct fit for Grass hinge plates and hardware clips.
The nickel finish gives the screw head a neutral metallic appearance that coordinates with the chrome and nickel tones common on European hinges and drawer slides. The coarse thread provides pull-out resistance in particleboard, MDF, and melamine-faced panels, which are the standard substrates in flat-pack and production cabinet construction. There are no nibs under the flat head on this screw, so the hole should be properly sized for the hardware plate before driving.
This screw belongs on the bench of anyone installing European concealed hinges or 32mm system hardware at volume. Cabinet shops assembling production runs, millwork teams fitting hardware on finished cases, and installers hanging frameless cabinetry on site all benefit from having a dedicated euro screw that matches the hardware specification rather than substituting a general-purpose fastener. The 1000-piece box supports continuous production without frequent restocking.
A euro screw mounts European cup hinges, drawer slides, and other 32mm system hardware to the interior faces or edges of cabinet panels. It threads into pre-bored 5mm holes rather than self-starting into solid material.
Yes. This screw is listed for use with Grass hardware and is sized for the pre-bored mounting holes in Grass hinge plates and hardware clips.
The blunt point is designed to thread into a pre-bored hole, not to pierce undrilled material. Euro screws go into line-bored holes that are already the correct diameter for the screw shank, so a self-starting tip is not needed and would not improve performance here.
Yes. The coarse thread is well suited to particleboard, MDF, and melamine-faced panels, which are the most common substrates in European-style cabinetry.
Yes. The drive size is #2 Phillips, which fits the standard #2 Phillips bits found in most shops and installation kits.
When the hinge plates are lined up and the holes are bored, the last thing a production run needs is the wrong screw. This Würth euro screw is sized, threaded, and finished for exactly this job, so the hardware goes on cleanly and the cabinet moves down the line.
Sold In: 1000 Each