Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #5 x 13mm flat head Euro screw is the dedicated fastener for mounting Grass European cup hinges, drawer slides, and related cabinet hardware into the 5mm line-bored holes of 32mm system cabinetry. With a Nickel finish, 7.5mm flat head, and #2 Phillips drive, it seats flush and clean in production cabinet work.
Euro screws occupy a specific role in cabinet construction: they are not general-purpose wood screws, and they are not confirmat fasteners. They are the short, pre-bored-hole fasteners that lock European hinge plates and drawer slide mounting clips to the interior faces of cabinet panels. The 5mm line-bore holes in a 32mm system cabinet are drilled to receive exactly this screw. The blunt point starts cleanly in the pre-bored hole without wandering, and the Euro thread engages the particleboard, MDF, or plywood panel with the thread geometry matched to that bore diameter. At 13mm in length, this screw provides solid thread engagement without over-penetrating a standard 3/4-inch (19mm) cabinet panel.
The Nickel finish coordinates with the satin and polished metal finishes common on Grass hinge cups, mounting plates, and slide hardware, so the fastener heads visible inside the cabinet remain visually consistent with the hardware. The 7.5mm flat head sits flush against the face of hinge mounting plates and slide brackets, avoiding any proud-head interference with door swing or drawer travel. No nibs are present on the underhead bearing surface, which is appropriate here since the screw seats against a metal mounting plate rather than directly into wood.
Cabinet shops building kitchen, bath, or furniture cabinetry with Grass European hinges and undermount or side-mount drawer slides will go through Euro screws in volume. Every hinge plate takes two or more screws, every slide bracket takes its own set, and a production run of 50 cabinet boxes can consume several hundred fasteners quickly. The 10,000-piece box is the practical format for shops that do not want to interrupt a run to reorder. Installers working from pre-assembled cabinets and designers specifying hardware packages can also use this as the standard replacement screw for Grass hardware service calls.
Euro screws install into pre-bored 5mm holes, not into undrilled material. A blunt point seats squarely in the bore and starts threading immediately. A sharp or self-tapping point would not improve performance here and could wander in the pre-drilled hole.
The product attributes specify Grass as the intended hardware. The 5mm Euro thread is a broadly used dimension in European cabinet hardware, but thread pitch and head geometry can vary between hardware brands. Confirming fit with non-Grass hardware before a full production run is worthwhile.
Yes. Grass hinge mounting plates are designed around this head diameter. The flat head seats flush against the plate surface without requiring a countersink in the panel itself.
It can be used in solid wood panels with a properly sized 5mm pre-bored pilot hole, but Euro screws are engineered primarily for the particleboard and MDF panels common in 32mm system cabinetry. Thread engagement and holding power in solid wood depend on grain direction and hole accuracy.
A standard #2 Phillips bit. No specialty bit is needed.
At 10,000 pieces per box, this Würth Euro screw is stocked for the pace of a real cabinet shop — enough fasteners on hand to run through a full kitchen without a parts delay.
Sold In: 10000 Each