Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #6 x 1-1/2-inch modified pan head face frame and pocket-hole screw is sized specifically for joining 3/4-inch hardwood cabinet stock. Fine thread, a Type 17 auger point, and a #2 square drive combine to pull face frame joints tight in maple, oak, cherry, and similar hardwoods without splitting or excessive driving torque.
At 1-1/2 inches, this screw is the standard length for pocket-hole joints in 3/4-inch material. That length gives the screw enough thread penetration into the second member to pull the joint closed while stopping short of breaking through the back face. It covers the two most common face frame operations: joining rails to stiles and attaching a finished face frame to the cabinet box. In both cases the modified pan head bears flush against the pocket shoulder, clamping without rocking or tilting.
Hardwood face frames, whether maple, oak, cherry, or walnut, demand a fine thread. Coarse threads in dense, tight-grained stock tend to push fibers apart rather than engaging them cleanly, and the result is a joint that feels soft or can split a narrow stile. Fine thread on this screw cuts into the grain rather than wedging through it, so the joint pulls together firmly. The Type 17 auger point reinforces this by milling a clean entry channel ahead of the threads, lowering the torque needed to drive and reducing stress on stock near the edge of the frame member.
Cabinet shops running production face frames in hardwood will find this screw covers the everyday pocket-hole and direct face frame attachment work in one SKU. The 1-1/2-inch length is the right call for 3/4-inch rails and stiles joined at the pocket, as well as for face frame-to-box attachment through a single thickness of material. It is equally useful for custom one-off cabinet builds and smaller millwork shops that run hardwood species and need a screw that drives cleanly without babying the joint. This is an indoor-only screw; the zinc finish is suited to the dry environment inside a finished cabinet, not to exterior or high-humidity applications.
Fine thread is required for hardwood face frame work. In dense species like maple and oak, a coarse thread creates excess radial pressure that can split the stile or produce a soft joint. Fine thread engages the grain more cleanly and delivers better holding power in tight-grained wood.
Yes. For 3/4-inch stock joined with a pocket-hole jig, 1-1/2 inches is the standard specification. The screw gets enough thread bite in the second member to pull the joint tight without risking breakthrough on the back face.
The Type 17 auger point has a fluted tip that mills a channel through wood fibers as the screw starts. In hardwood, this reduces the driving torque needed and lowers the stress on the material near narrow stile edges, where splitting risk is highest.
The square recess is designed to hold the screw on a correctly sized #2 bit for one-handed placement, which is useful when driving into angled pocket holes. The result depends on using a properly sized bit; an off-spec or worn bit will not hold as securely.
It will drive into softwood, but fine thread is not the best choice for low-density materials like pine, MDF, or particleboard. Coarse thread provides better pull-out resistance in those substrates. Use this screw where hardwood face frame work is the job.
When the thread, point, length, and head all match the material, a face frame joint closes cleanly on the first drive. This Kreg 1-1/2-inch fine-thread screw is built for exactly that outcome in hardwood cabinet work.
Sold In: 1 Box