
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
This Blum #7 x 1/2" flat head screw is engineered for mounting European-style hinges and drawer slides to cabinet panels. With a Phillips drive, fine thread, and sharp point, it seats cleanly in the pre-drilled holes of Blum hinge plates, drawer slide mounting brackets, and similar hardware without requiring a pilot hole in most panel substrates.
Hinge plates, drawer slide clips, and lift-system mounting brackets all arrive with pre-bored holes sized for a specific screw gauge. The #7 x 1/2" dimension puts enough thread in the panel to hold the hardware securely while keeping the screw short enough not to penetrate the visible face of 3/4" cabinet panels. It is the correct size for Blum Aventos hinge plates and a range of other Blum mounting plates that call for a #7 screw. For shops running Blum hardware throughout a kitchen or bath project, keeping a box of these on hand means hardware goes up without a fastener hunt mid-install.
The nickel finish is a practical match for Blum's hardware finishes, so screw heads visible inside the cabinet or on a hinge plate read as part of the hardware rather than a contrast element. The flat head profile seats against the countersunk or flat bearing surface on standard Blum mounting plates without standing proud of the plate face.
Cabinet shops running Blum hardware in volume are the core buyer. Installers who pull pre-built Blum-equipped boxes to a job site and need a reliable supply of the correct installation screw are equally well served. The 100-piece box suits both a production run on a single kitchen project and replenishing the service bag a field installer carries to each job.
Yes. The SAP description references Aventos hinge plates specifically, and the #7 x 1/2" size is the standard mounting screw for Blum Aventos and similar hinge plate hardware.
Fine thread provides tighter thread engagement, which suits the harder substrates and thin cross-sections found in hinge plate mounting holes. It also reduces the risk of stripping the hole when hardware is removed and reinstalled during adjustment.
The #7 x 1/2" flat head Phillips screw is used across a range of Blum hinge plates and drawer slide mounting clips that call for a #7 gauge. Confirm the hardware manufacturer's specification for any plate or clip before substituting.
The sharp point self-starts in pre-drilled hinge-plate holes. Most Blum hardware arrives with the mounting holes already sized for the screw, so no additional pilot drilling is needed in standard cabinet panel substrates.
A #2 Phillips bit drives this screw. That is the same bit used for most cabinet installation work, so no additional tooling is required.
When the hardware calls for a #7 x 1/2" screw and the install needs to keep moving, this Blum-supplied nickel Phillips screw is the correct fastener, sized and finished for the application.
Sold In: 100 Each