Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Blum #6 x 5/8-inch flat head wood screw is a production-grade installation fastener designed for mounting European cabinet hardware — hinges, drawer slides, and related fittings — to cabinet panels and face frames. With a Pozidriv drive, coarse thread, and nickel finish, it pairs directly with Blum hardware and the close tolerances of European-style cabinetry.
Cabinet hardware installation demands a short, precise screw that seats cleanly in hardware mounting plates without over-penetrating the panel. At 5/8 inch, this screw is sized for the shallow engagement depth of European cup hinge plates, drawer slide mounting clips, and similar hardware on 3/4-inch cabinet stock. The flat head sits flush against the plate face, and the coarse thread grips plywood, particleboard, and MDF reliably. Blum specifies hardware with pre-drilled holes sized for a #6 gauge, so this screw drops in without guesswork on gauge compatibility.
The Pozidriv drive was engineered specifically to address the cam-out tendency of standard Phillips heads under power-tool torque. Its eight-point engagement geometry — four primary arms plus four secondary ribs — maintains positive bit contact through the full seating stroke. For a cabinet installer driving dozens or hundreds of hinge and slide screws in a session, that translates to fewer stripped heads and less time correcting drive-out errors. The nickel finish is a practical detail: inside a finished cabinet, hardware and fasteners in the same finish family look intentional rather than incidental.
This is the screw for cabinet shops and installers who run Blum hardware and want a fastener that matches both the mechanical spec and the finish of the hardware they are mounting. It suits high-volume production shops working through full kitchen and bath runs, as well as finish carpenters and installers who want clean results on individual jobs. The 1,000-piece box is sized for shops that move through hardware at production pace — enough to keep the line going without carrying excessive inventory. It is an indoor screw for wood-based panel material; it is not rated for exterior or high-moisture applications.
It is designed for mounting Blum cabinet hardware — including European cup hinges, drawer slides, and related fittings — to cabinet panels. The #6 gauge and 5/8-inch length match the mounting-plate hole specifications common to Blum hardware.
It requires a #2 Pozidriv bit. A standard #2 Phillips bit will fit physically but does not fully engage the Pozidriv recess, which increases the chance of cam-out and head damage. Use the correct Pozidriv bit for best results.
Yes. The coarse thread is suited for wood-based panels including plywood, particleboard, and MDF — the materials most commonly used in cabinet box construction.
No. This is an indoor fastener. For exterior or wet-environment installations, use a screw with a corrosion-resistant coating rated for that exposure.
When the screw matches the hardware — in gauge, length, drive, and finish — installations go faster and the finished cabinet looks right. This Blum screw is the straightforward choice for shops and installers who want everything to line up the first time.
Sold In: 1000 Each
