Blum #7 x 3/4" Flat Head Wood Screw Phillips Drive - Sharp Point Coarse Thread Nickel, 28006353 - 100/Box

A 3/4-Inch Wood Screw Sized for Cabinet Hardware Mounting

The Blum #7 x 3/4-inch flat head Phillips wood screw is a short-shank installation screw designed to mount cabinet hardware — hinges, drawer slides, and similar components — to panel faces and face frames without over-penetrating the material. The 3/4-inch length makes it a practical match for standard 3/4-inch cabinet panels where a longer screw would push through the far face.

Key Features

• Flat head profile seats flush or below the material surface for a clean, low-profile installation.
• #2 Phillips drive accepts a standard #2 Phillips bit, the most common bit on any install crew.
• Coarse thread bites quickly into solid wood and wood-based panels.
• Sharp point self-starts without a pilot hole in most cabinet panel materials.
• Nickel finish blends with Blum hardware in white or light-interior cabinet builds.
• 100 screws per box supplies a typical hardware installation run without overbuying.

Where the 3/4-Inch Length Fits Best

At 3/4 inch, this screw is specifically sized for cabinet panel work where depth matters. Hinge mounting plates, drawer slide clips, and similar hardware attach to the interior face of a 3/4-inch panel — and a screw that runs much longer risks breaking through the panel's opposite face or into a visible surface. The sharp point and coarse thread engage the panel material quickly, so the head seats without requiring excessive driving force. This length is also well suited for attaching hardware to solid wood face frame members where the stock thickness limits how deep a fastener can go.

Nickel Finish on a #7 Gauge Shank

The nickel finish coordinates with Blum's own hardware finishes, which is useful when screws are visible inside a cabinet box or behind an open door. The #7 gauge shank occupies the size range between the lighter #6 and the heavier #8, giving it enough body to hold a mounting plate securely while still fitting the pre-bored holes found in most Blum hardware. The flat head countersinks into the mounting hole and sits flush, keeping the hardware plate tight against the panel face.

Built for Cabinet Shops and Installers

This screw is a natural fit for cabinet shops that build and install Blum-equipped cabinets, and for installers swapping or adding Blum hardware to finished boxes on site. The 100-count box covers a typical project run — enough to mount a kitchen's worth of hinges and slides — without requiring a large inventory commitment. Keeping a box on the bench means the right screw is always at hand when a mounting plate needs to be secured or re-seated.

Frequently Asked Questions

The Right Screw for the Job at Hand

When the job is mounting Blum hardware to 3/4-inch cabinet panels, this flat head Phillips screw in a 100-count box keeps the work moving without the delay of hunting for the right fastener.