Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Blum #7 x 5/8-inch flat head wood screw is designed for mounting cabinet hinges, drawer slides, and other hardware to panel substrates where penetration depth must stay controlled. The 5/8-inch length keeps the screw well within standard 3/4-inch cabinet panels, and the flat head seats flush for a clean, finished installation.
Hardware mounting in cabinetry often happens on panels where depth is limited. A standard 3/4-inch panel leaves little room for error, and a screw that runs too deep can telegraph through the face or compromise a finished surface. At 5/8 inch, this screw engages the panel fully while keeping a safe margin from the opposite face. It is the right call when mounting Blum hinges, drawer slide brackets, or clip-on hardware plates to melamine, particleboard, or MDF cabinet sides and bases where panel thickness is the constraint.
The Nickel finish coordinates with Blum's hardware line, so screw heads visible inside a cabinet interior or along a hinge plate stay visually consistent. The flat head profile countersinks cleanly through hinge mounting plates and hardware flanges, seating flush without standing proud. Coarse-thread geometry provides solid pull-out resistance in the engineered wood substrates that make up most production cabinet boxes, and the sharp point self-starts across particleboard, MDF, and plywood without requiring a separate pilot step.
Cabinet shops running Blum hinge and drawer systems keep this screw on hand to match their hardware precisely. The 100-piece box suits installers working through a kitchen or bath project and production shops that want a dedicated hardware screw rather than a general-purpose substitute. It is also a practical reorder for service calls where a missing or stripped screw needs an exact replacement that matches the original hardware finish and head profile.
Yes. The 5/8-inch length engages the panel without breaking through the opposite face, which is the main reason it suits 3/4-inch cabinet panel work.
The flat head is designed to countersink through a hardware mounting plate and seat flush, leaving no protrusion above the plate face.
The sharp point self-starts in particleboard, MDF, and plywood without a pilot hole in most cases. Driving into hardwood or very close to an edge may benefit from a pilot hole to reduce splitting risk.
It is a standard #7 flat head wood screw. While it is sized and finished to match Blum hardware, it fits any application calling for a #7 x 5/8-inch flat head Phillips screw with coarse thread.
A #2 Phillips bit drives this screw.
When length and head profile have to be exactly right, this Blum #7 x 5/8-inch flat head screw gives hardware installers and cabinet shops a purpose-matched fastener that seats flush, stays within the panel, and holds without fuss.
Sold In: 100 Each
