Blum #6 x 3/4" Flat Head Wood Screw Phillips Drive - Sharp Point Coarse Thread Nickel, 28003333 - 1000/Box

3/4 Inch Length And A Flush Fit For Cabinet Hardware Work

The Blum #6 x 3/4" flat head wood screw is a Nickel-finish Phillips drive screw built for mounting cabinet hardware to wood panels and frames. At 3/4 inch long, it is sized to seat firmly in face-frame stock and cabinet panels without over-penetrating, making it a dependable choice for hinge plates, drawer slide brackets, and similar hardware installations.

Key Features

• 3/4 inch length sized to fasten into face-frame stock and panel faces without breaking through.
• Flat head with a #2 Phillips drive countersinks flush for a clean, low-profile installation.
• Coarse thread on a #6 shank provides solid pull-out resistance in solid wood and wood-based panels.
• Sharp point starts cleanly in wood without a pilot hole in most cabinet materials.
• Nickel finish coordinates with Blum hardware finishes in visible cabinet interiors.
• 1,000 screws per box keeps a busy installation or production run supplied without frequent reorders.

Where the 3/4 Inch Length Makes Sense

The 3/4 inch length is a practical match for mounting hardware to single-layer face-frame stock or the face of a 3/4 inch panel. It drives deep enough to hold a hinge baseplate or drawer slide bracket securely while stopping well short of the panel back. For shops installing European cup hinges, this screw fits the standard mounting plate holes and sits flush once driven. The flat head countersinks into the pre-bored seat in the hardware, leaving no protrusion that would prevent the hardware from seating flat against the wood surface.

Nickel Finish and Construction

The Nickel finish gives the screw head a clean, coordinated look when it is visible inside a cabinet — alongside Blum hinges, drawer slides, and other Nickel-finish hardware. Beyond appearance, the coarse thread engages solid wood, plywood, and MDF reliably at this gauge, and the sharp point keeps starts quick across repeated installations. The flat head profile is designed to countersink flush so the hardware sits tight against the mounting surface without rocking or gapping.

Who Reaches for This Box

Cabinet shops running European hardware installations use this screw to keep their hinge and drawer-slide work moving without switching between fastener types. Finish carpenters and installers who set pre-hung cabinets on site find the 3/4 inch length useful when fastening hardware to face frames before the box goes on the wall. A box of 1,000 suits either setting: it supports a multi-day production run in the shop or stays in the install kit as a reliable refill for everyday hardware mounting.

Frequently Asked Questions

Hardware Mounting That Stays Consistent

When every hinge plate and slide bracket seats the same way from the first cabinet to the last, installation moves faster and finished gaps stay even. This screw is the consistent, finish-matched fastener that makes that kind of repeatability easy to maintain.