Cream Cabinet Profile Spacer Built for METABOX Drawer Systems

This 4mm screw-on cabinet profile spacer is made for Blum's METABOX STANDARD 230M and 430 drawer systems, letting installers fine-tune the gap between the cabinet member and the cabinet panel so the drawer sits level and the front aligns correctly out of the gate.

Key Features

• 4mm spacing in a stackable design — combine multiples to build up the exact offset your install requires without cutting or shimming.
• Cream finish — blends with white and off-white cabinet interiors so the spacer stays visually quiet behind the drawer system.
• Screw-on mount — fastens securely to the cabinet member using the existing screw points, with no additional hardware to source.
• Designed for METABOX 230M and 430 series — the profile is shaped to the METABOX cabinet member geometry, so it seats correctly and does not shift under load.
• 5/32 inch (4mm) thickness — a precise, consistent increment that makes stacking predictable when more offset is needed.

Where This Spacer Earns Its Place

Cabinet panels are rarely perfectly flat, and METABOX slides mounted directly to a bowed or misaligned panel can throw off drawer front alignment across an entire run of cabinets. This spacer creates a reliable standoff between the cabinet profile and the panel surface, so the slide sits at the intended geometry regardless of minor panel variation. It is especially useful in production shops where a consistent shimming strategy across a run of identical cabinets saves adjustment time at install. Stackable spacing also helps when a design calls for a slightly recessed or offset drawer position that a single mounting point alone cannot achieve.

Material and Finish

The spacer is molded in cream, a tone that reads as neutral inside most white and off-white melamine or painted cabinet interiors. In a METABOX installation the cabinet profile and its hardware sit behind the drawer box and are not visible in normal use, so the finish is primarily about avoiding visual contrast if the drawer is ever fully removed for service. The screw-on design holds the spacer firmly against the cabinet member — it does not slip or compress over time the way an improvised shim would.

Who Should Keep These on Hand

Cabinet shops running METABOX 230M or 430 series drawers in any volume will find it practical to stock these spacers alongside their slide inventory. A missing spacer mid-install means either improvising a shim or pulling the drawer apart and delaying the job. Installers working in face-frame cabinets with deeper-than-standard frame offsets will reach for these often, as will shops whose panel stock runs slightly thicker than nominal and pushes the slide position inward. This is a Blum system-specific part — it fits METABOX, not TANDEM or other Blum drawer platforms.

The Right Fit for a Clean METABOX Install

A 4mm spacer is a small part, but getting drawer alignment right across a full cabinet run depends on consistent, repeatable standoffs — and this Blum-matched cream spacer delivers exactly that for METABOX 230M and 430 installations.