Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #14 x 2-1/2 inch Face Frame and Pocket-Hole Screw is sized for joints where standard shorter pocket-hole screws fall short. Fine thread, a Type 17 Auger point, and a modified pan head come together in a screw built for face frame work and pocket-hole joinery in thicker material.
This length is the right call when the joint demands more reach than a 1-1/4 inch or 1-1/2 inch screw can provide. Attaching thick face frame stock to a cabinet box, joining doubled-up stiles, or driving through a deep pocket into thick lumber are the moments where 2-1/2 inches earns its place. The fine thread bites consistently in hardwoods like maple, oak, and cherry, materials that coarse-thread screws can push past without gripping cleanly. The Type 17 Auger point reduces the torque needed to drive through those dense grains, which means less risk of cam-out or snapped heads mid-joint.
The modified pan head sits flat against the angled pocket bore surface and draws the joint closed without the head sinking into the wood or splitting the stock face. That flat bearing surface keeps clamping force distributed evenly across the joint. The #2 square drive is designed to hold the screw on a correctly sized bit, which matters when working overhead or in tight cabinet interiors where repositioning a dropped screw slows the job down. Each box holds 30 screws, sized for focused project use or supplementing larger stock on a specific run.
Cabinet shops building hardwood face frames on taller base cabinets and upper cabinets with thicker applied sides will find the 2-1/2 inch length fits naturally into their pocket-hole workflow. Finish carpenters joining thick built-in components or attaching face frames to furniture-grade casework with deeper-than-standard pockets use this length where shorter screws leave thread engagement on the table. The zinc finish is suited to dry indoor work, which covers the majority of cabinet and millwork applications where this screw belongs.
The fine thread is optimized for hardwoods such as maple, oak, cherry, and walnut. For softwood, sheet goods, or MDF, a coarse-thread pocket-hole screw is the better fit.
This length is suited for thicker face frame stock, deep pocket bores, or joints where additional thread engagement is needed for a firm pull. Check your pocket-hole jig's chart for the recommended screw length for your specific stock thickness.
The auger flute clears wood fibers and reduces driving torque in dense hardwood, but a pocket bore from a jig is still the intended installation method. The point helps the screw seat cleanly once the pocket is cut.
A #2 square drive bit. The square recess is designed to hold the screw on a correctly sized bit for controlled placement during installation.
No. The zinc finish is rated for dry interior environments. For outdoor or moisture-exposed joinery, use a screw with a corrosion-resistant coating rated for exterior exposure.
When the joint calls for more reach and the material is hardwood, the Kreg #14 x 2-1/2 inch pocket-hole screw covers both needs in one fastener, keeping face frame and casework assembly moving without compromise.
Sold In: 1 Box