Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #14 x 2-1/2 inch face frame and pocket-hole screw is sized for joints where stock thickness or combined panel depth calls for extra length. The fine thread, modified pan head, and Type 17 Auger point work together to pull hardwood joints tight and seat cleanly without splitting narrow or dense stock.
Most pocket-hole face frame work uses shorter screws sized for 3/4-inch stock, but there are common situations where 2-1/2 inches is the right call. Attaching a face frame to a cabinet box built from thicker stock, joining a face frame to an applied end panel, or running pocket screws through a rail into a wider stile all create joint depths that shorter screws cannot fully engage. The 2-1/2 inch length reaches across those thicker assemblies and still pulls the joint closed. It also suits edge-band or applied molding details where the combined material thickness exceeds what a standard 1-1/4 inch or 1-1/2 inch screw can bridge.
Hardwood face frames — maple kitchen cabinets, oak built-ins, cherry vanity faces — need a screw that grips without splitting. A coarse thread in tight-grained hardwood strips or forces the fibers apart; fine thread bites progressively and holds more reliably in those dense materials. The modified pan head completes the picture: it seats flat against the pocket wall and clamps the joint rather than wedging into it, which matters when you are driving into a narrow rail or stile where a bugle or countersunk profile would risk blowout. The Type 17 Auger point reduces the torque spike at penetration, keeping driving smooth in hardwood where resistance builds quickly.
Cabinet shops running hardwood face frame production keep a box of these alongside their shorter pocket-hole screws for the jobs where standard lengths come up short. Finish carpenters attaching site-built face frames to thicker structural panels reach for the 2-1/2 inch when the combined stock depth adds up. Woodworkers building furniture with applied frames, entry surround work, or paneled wainscoting find the extra length useful when joinery runs through more than a single layer of material. For indoor work on hardwood or dense engineered panels, this screw covers the range that shorter face frame screws cannot.
Fine thread is the correct choice for hardwood face frames. Coarse thread can force dense wood fibers apart and lose holding power in tight-grained species like maple or oak. Fine thread engages those fibers progressively and holds without splitting.
The 2-1/2 inch length is intended for joints where combined stock depth exceeds what a standard 1-1/4 or 1-1/2 inch screw can fully engage. Common situations include attaching face frames to thicker cabinet boxes, joining frames through applied end panels, or fastening rails into wide stiles where the pocket runs deeper than usual.
The square recess is designed to hold the screw on a correctly sized #2 bit for single-handed placement. The fit depends on using a properly sized bit; a worn or off-spec bit will not provide the same retention.
Fine thread is optimized for hardwood. For softwood, plywood, MDF, melamine, or particleboard face frames, a coarse-thread pocket-hole screw in the appropriate length will perform better.
The zinc finish on this screw is rated for dry indoor use. It is not intended for exterior, pressure-treated lumber, or high-humidity applications.
When the assembly is hardwood and the joint runs deeper than standard pocket-hole lengths allow, the Kreg #14 x 2-1/2 inch fine-thread face frame screw covers the gap without changing tools or technique.
Sold In: 1 Box