Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Quickscrews #6 x 3/4-inch flat head hinge and drawer slide installation screw is built for mounting European cup hinges, side-mount drawer slides, and similar cabinet hardware to 3/4-inch cabinet panels. The square drive, Type 17 auger point, coarse thread, and nickel finish are matched to the demands of production cabinet installation.
At 3/4 inch, this screw is sized to engage a standard 3/4-inch cabinet side, end panel, or face frame without penetrating through. That makes it the correct length for mounting hinge plates and drawer slide brackets to the interior faces of frameless and face-frame cabinets built from 3/4-inch sheet stock. The Type 17 auger point starts cleanly and pulls the mounting plate tight to the panel surface, and the flat head seats flush through the countersunk holes in most hinge and slide hardware.
The nickel finish on this screw is practical as well as visual. Inside a cabinet, exposed screw heads on hinge plates and drawer slide brackets are visible when doors and drawers are open. A nickel-finished screw head reads as part of the hardware rather than a contrasting element, which matters in kitchens and baths with satin or brushed nickel pulls and hinges. The coarse thread and #6 gauge are sized to match the pre-bored holes common in European hinge mounting plates and standard drawer slide brackets, so the head seats without standing proud of the plate surface.
This screw is the right choice for cabinet manufacturers running production lines, installers hanging pre-built cabinets on site, and finish carpenters completing kitchen and bath remodels. The square drive reduces cam-out during repeated driving, which matters when installing dozens of hinges and drawer slides in a single session. Packed at 1,000 per box, the quantity supports a full cabinet run or a multi-cabinet installation job without mid-job restocking.
Standard cabinet carcass panels are 3/4 inch thick. A 3/4-inch screw enters through the hardware mounting plate and engages the full depth of the panel without breaking through the opposite face. For thicker panels or through-fastening applications, a longer length would be needed.
Yes. Most European hinge mounting plates and drawer slide brackets use countersunk holes sized for a #6 flat head screw. The flat head seats flush through the plate without standing above the bracket face.
The screw uses a #2 square drive recess. A correctly sized #2 square bit provides good engagement and helps hold the screw on the bit during placement.
Yes. The coarse thread is well matched to plywood, MDF, and particleboard, which are the most common carcass materials in production and semi-custom cabinet construction.
When hinge plates and drawer slide brackets are visible inside the cabinet, nickel-finished screw heads blend with satin and brushed nickel hardware finishes. In kitchens and baths where hardware finish consistency matters, the nickel head avoids the visual mismatch of a silver or gold-toned screw against a nickel-finished plate.
When the length, thread, head, and finish all match the hardware and the panel, installation moves without interruption. This Quickscrews #6 x 3/4-inch screw is stocked and sized specifically for that job.
Sold In: 1000 Each