Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg SPS-F150-1200 is a #6 x 1-1/2-inch face frame and pocket-hole screw built for joining 3/4-inch hardwood face frame members. Fine thread, a Type 17 Auger point, and a modified pan head work together to pull hardwood rail-to-stile joints tight without splitting the stock. Packed 1200 to the box.
At 1-1/2 inches, this screw is the standard length for pocket-hole joints in 3/4-inch face frame stock. The screw enters through the angled pocket bore and threads fully into the mating stile or rail, pulling the joint closed without breaking through the face. Shops working with standard cabinet-grade hardwood — maple, oak, cherry — will find this length handles the most common face frame thickness without adjustment. For thicker stock or layered assemblies, a longer screw from the same family is the better fit.
These three elements are matched to hardwood face frame work. Fine thread bites into tight-grained hardwood and resists stripping under the torque needed to close a joint cleanly. The Type 17 Auger point uses a longitudinal flute to remove wood fibers and reduce splitting pressure, which matters most in dense species and in joints drilled close to the board edge. The modified pan head provides a broad, flat bearing surface that distributes clamping force evenly across the pocket wall rather than wedging into it. Together they produce a joint that closes flush and holds without surface damage to the face frame.
Cabinet shops running hardwood face frames on kitchen and bath cabinetry will use this screw most. It also works for furniture makers joining hardwood frames, craftsmen building face-frame bookcase or entertainment center carcasses, and finish carpenters attaching face frames to cabinet boxes at the job site. The 1200-piece box suits shops with regular production output. If the work is primarily in softwood, pine, or sheet goods like plywood, a coarse-thread version is the correct choice for those materials — fine thread is optimized for hardwood.
Hardwood has a denser, tighter grain than softwood or sheet goods. Fine thread engages more fiber per inch of shank, which provides better holding power in these materials and resists stripping when the driver closes the joint under load. A coarse-thread screw in dense hardwood can strip the pocket before the joint fully closes.
For 3/4-inch material with a fine-thread screw, follow the jig manufacturer's setting for 3/4-inch stock thickness. Kreg jigs include a depth collar setting and a drill guide for this thickness. Refer to the guide included with your jig for the exact collar position.
Yes. The modified pan head and fine thread work well for face frame attachment when the face frame stock and the cabinet panel are both 3/4 inch and the joint is being driven from the back of the panel into the face frame. Confirm the combined thickness and penetration depth match the 1-1/2-inch length before driving.
In standard pocket-hole use, the pocket bore itself acts as the pilot. The Type 17 Auger point handles thread engagement in the mating piece without a separate pilot. In very dense hardwood driven outside a pocket, a pilot hole reduces splitting risk.
The zinc finish is rated for dry interior work. It is not suited for exterior use, damp environments, or pressure-treated lumber. Outdoor face frame or structural work calls for a screw with a corrosion-resistant coating rated for those conditions.
When face frame joinery is a daily production task, the right screw eliminates the small failures — stripped pockets, split stiles, joints that need re-driving — that slow a shop down. The Kreg SPS-F150-1200 is dialed in for that work: the right length for 3/4-inch stock, the right thread for hardwood, and enough screws per box to keep the job moving.
Sold In: 1 Box