Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #6 x 5/8-inch flat head hinge and drawer slide installation screw is sized for mounting European cup hinges, side-mount drawer slides, and similar cabinet hardware to panels where penetration depth must stay well within the panel thickness. The coarse thread, Type 17 Auger point, and #2 square drive make it a reliable choice for high-volume cabinet assembly and installation work.
Cabinet hardware mounting plates are drilled for short screws. The 5/8-inch length gives enough thread engagement through the plate and into the panel face without approaching the panel's opposite surface. That matters on frameless cabinet boxes where hinge or slide screws driven too deep push through and mar the visible interior finish. This screw is sized to reach the wood behind the mounting plate and stop there, which is exactly what most European hinge and side-mount drawer slide installations call for.
The #2 square drive recess is cut to hold the screw on a correctly sized bit, which matters when placing screws into the small holes of a hinge mounting plate in a tight cabinet opening. The Type 17 Auger point flute clears material from the hole as the screw advances, keeping driving torque low and reducing stress on the wood fibers around the mounting hole. Coarse thread completes the combination by gripping plywood and solid wood faces firmly through the hardware footprint. Together these three features support fast, repeatable installation without cam-out or split-out at the mounting location.
Cabinet shops running European hinge and undermount or side-mount drawer slide installations in volume keep a box of these on the bench or in the cart. Installers setting built-in cabinetry on site use them when the hardware goes in after delivery. The 1000-piece box suits both settings: enough volume to work through a full kitchen run without restocking mid-job, and a quantity that fits the pace of a production shop running hinge and slide hardware all day. The zinc finish is the right call for dry, indoor cabinetry where standard corrosion protection is all that is needed.
Yes. With typical hinge and drawer slide mounting plate thickness factored in, the 5/8-inch screw seats the plate firmly and stops well short of the panel's back face, preventing tip blowout on the finished interior surface.
The box contains 1000 screws. A separate #2 square drive bit is not included with this pack. Any standard #2 Robertson-style bit fits the recess.
Yes. The flat head, coarse thread, and 5/8-inch length are sized for the mounting plates used on European cup hinges and side-mount drawer slides in standard cabinet panel thicknesses.
The coarse thread and Type 17 Auger point work in plywood and solid wood face-grain applications. In low-density engineered panels like particleboard or MDF, pull-out resistance is lower than in plywood. For those substrates, confirm that the panel density is sufficient for the hardware load before specifying.
This screw carries a standard zinc electroplated finish suited for dry, indoor cabinet installations. It is not rated for exterior, wet, or high-humidity environments.
When the length, drive, and thread are matched to the job, hinge and slide hardware goes in fast, seats flush, and stays put. This Würth #6 x 5/8-inch square drive installation screw is that match for standard indoor cabinet panel work.
Sold In: 1000 Each