Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #6 x 3/4" flat head hinge and drawer slide installation screw is designed for mounting European cup hinges, drawer slides, and other cabinet hardware to panel faces where a short fastener is required. The flat head seats flush in the countersunk holes of standard hardware mounting plates.
The 3/4" length is the practical choice when the cabinet panel is 3/4 inch thick and full penetration is the goal, or when panel thickness is closer to 1/2 inch and a short amount of embedment is acceptable. It is the standard length for attaching European concealed hinge mounting plates to frameless cabinet sides and for securing drawer slide clips to the interior face of a cabinet panel. At this length, the screw engages enough material to hold hardware securely under repeated door and drawer cycling without breaking through the opposite panel face. It is also well matched to the mounting plates of most undermount and side-mount drawer slide hardware, where the pre-drilled holes accept a #6 gauge head and the panel behind them is 3/4 inch stock.
The #2 square drive is the shop standard for hinge and slide installation because it resists cam-out under the continuous torque of a cordless driver. The Type 17 Auger point clears material as the screw enters, which matters in high-density particleboard and MDF where a plain sharp point can stall or raise the panel face. The zinc finish suits interior cabinetry: it provides adequate protection in a dry shop or finished kitchen environment. These screws are for indoor cabinet work, not for exterior hardware or any environment with direct moisture exposure.
Cabinet shops running European frameless construction will go through these at volume. The 1,000-piece box is sized for production: a shop installing 50 cabinets with six hinge plates each, plus slide hardware, easily uses several hundred screws in a single day. Installers working on site can keep a box in the tool bag and not worry about running short mid-job. The square drive also means a single bit handles every screw on the job, which keeps the pace steady when working through a full kitchen installation.
Most European hinge mounting plates are designed for 3/4 inch cabinet panels. A 3/4 inch screw penetrates the full panel thickness without breaking through the exterior face, giving the threads maximum engagement in the material behind the plate.
Yes. The coarse thread is designed for engineered panel materials including particleboard, MDF, and plywood, which are the standard substrates in European frameless cabinetry. The Type 17 Auger point reduces driving torque and minimizes surface disruption as the screw seats.
This screw accepts a #2 square drive only. A Phillips bit will not engage the square recess. Keep a #2 square bit in the driver you use for hardware installation.
In most cases, no. The Type 17 Auger point self-starts in plywood and engineered panels without a pilot hole. In very dense hardwood panels or when driving near an edge, a small pilot hole reduces splitting risk.
No. The zinc finish is rated for dry, interior conditions. For hardware exposed to moisture or installed outdoors, use a screw with a corrosion-resistant coating appropriate for the environment.
When the job calls for a #6 x 3/4" flat head screw that starts fast, seats flush, and holds hardware through years of daily use, this Würth hinge and drawer slide installation screw covers it in a box sized for production work.
Sold In: 1000 Each