Nickel Concealed Hinge for Wide-Swing Half Overlay Doors

This Salice Series 200 hinge opens to 155 degrees and is built for half overlay doors on face-frame or frameless cabinets, delivering a near-flat swing that thick-door applications and wide-access cabinet layouts depend on.

Key Features

• 155 degree opening angle swings the door nearly flat for maximum access into the cabinet interior.
• Self-close spring pulls the door shut over the last few degrees of travel without a separate mechanism.
• Half overlay, half crank arm positions two doors correctly on a shared center partition or sets a partial overlay on a single door.
• Screw-on mounting fastens directly to the base plate for a fixed, stable connection.
• Works on face-frame and frameless cabinets when paired with a compatible Salice base plate, sold separately.
• Nickel finish on plated steel coordinates with brushed metal hardware across the kitchen or bath.

A 155 Degree Swing Where Access Counts

Most concealed cabinet hinges stop at 110 degrees, which suits everyday use. This hinge opens to 155 degrees, bringing the door nearly parallel with the cabinet side. That matters in specific situations: base cabinets where the door needs to clear the drawer box completely, corner installations where adjacent doors would otherwise restrict each other, and pantry or tall-cabinet layouts where unobstructed reach into the full depth of the box is the design goal. The half crank arm handles the half overlay geometry, including two doors that meet on a center partition where each door needs to cover only its half of the shared edge. The 35mm cup bores into the back of the door, and the arm connects to a Salice base plate fastened to the cabinet, ordered separately.

Steel Build with a Nickel Finish

The hinge body is plated steel in a nickel finish. Nickel reads as a warm, mid-tone brushed metal that works alongside satin nickel pulls, brushed nickel faucet hardware, and similar finishes common in transitional and traditional kitchens and baths. The screw-on connection at the base plate is a fixed mechanical joint, appropriate for doors that will be pushed to their full swing repeatedly. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm and minus 1.5mm give enough range to bring doors to an even reveal after the cabinet is set.

Where This Hinge Belongs

Reach for this hinge when a project calls for half overlay doors and the standard 110 degree opening is not enough. It suits cabinet shops specifying base cabinets that need to clear drawer hardware, designers laying out corner or peninsula runs where door swing is tight, and contractors retrofitting existing face-frame or frameless boxes where wider access is a client requirement. The screw-on plate connection is a straightforward, familiar install for any experienced installer. For a damped, cushioned close instead of a spring pull, the Silentia+ soft-close version of this series is the alternative to quote.

Common Questions

Full Swing, Clean Reveal, Reliable Close

Specify this hinge when a half overlay door needs to open wide, close on its own, and coordinate with the nickel hardware already on the job.