Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 26 inch full-extension side-mount ball bearing drawer slide from Knape and Vogt's 8650 series, rated 150 lb per pair with an integrated soft-close damper and a zinc finish suited to indoor cabinetry wherever a clean, hardware-blending look is preferred. It is sold in bulk-pack quantity for shops and contractors ordering in volume.
A loaded deep kitchen drawer — pots, cast iron, or heavy pantry stock — pushes past what a standard 100 lb cabinet slide is rated for and slams if there is no damper. The 8650 series addresses both at once: the 150 lb rating gives the slide the overhead for genuinely heavy contents, and the soft-close damper means the drawer settles shut quietly regardless of how firmly it is pushed. This pairing suits base cabinet drawers in production kitchens, shop storage cabinets with dense tooling, and utility drawers carrying hardware or bulk material. At 26 inches, the slide length also suits deeper base cabinets where a shorter slide would leave travel short of the opening.
Zinc is the standard finish for side-mount ball bearing slides installed in painted, melamine, or utility interiors. It provides indoor corrosion resistance without the color contrast that a black or white finish introduces against a neutral cabinet side. For shops running zinc-finished drawer slides throughout a cabinet line, the 8650 in zinc keeps the hardware consistent across load classes. This is not a decorative finish and it is not rated for wet or outdoor environments — it is a practical indoor finish that holds up through daily shop use.
Cabinet shops spec the 8650 when a project calls for soft-close performance at a higher load class than the standard kitchen slide delivers — a client's base cabinet with a deep drawer full of cookware, or a shop cabinet carrying organized hardware bins. Contractors find it useful on utility and laundry room builds where drawers carry real weight and slamming is a complaint. The non-handed design and bulk-pack format mean the box goes on the shelf and pulls for any drawer in the project without sorting. The 1/2 inch side clearance per side matches the standard side-mount format, so the drawer box sizing formula is the same one the shop already uses.
No. 26 inches is the closed slide length. Because this is a full-extension slide, the drawer member travels the full slide length and brings the entire drawer out to the cabinet face — but the travel spec and the slide length are two separate facts. The drawer opens to approximately its full depth, not beyond it.
No. This slide uses a damper that catches the drawer near closed and slows it to a quiet, controlled stop. A self-close ramp uses a spring to pull the drawer shut — it is not damped and can still slam. The 8650's soft-close is damped closing.
The 8650 series requires 1/2 inch of side clearance per side. Build the drawer box 1 inch narrower than the cabinet opening to leave the correct clearance for both slides.
No. The 8650FMB is non-handed — both slides in the pair are identical and fit either side of the drawer. Order by pair count, not by handedness.
Side-mount slides in face-frame cabinets need rear support at the back of the cabinet because the side panel is set back from the face frame. Add the matching rear mounting brackets for this series — they are sold separately and are series-specific.
When the drawer is deep, the load is heavy, and the finish has to blend in, the 8650 in zinc handles all three without compromise — 150 lb capacity, damped soft-close, and a finish that disappears into the cabinet interior.
Sold In: 1 Set
