Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune J95 Series concealed hinge brings a 5/8 inch half-overlay self-close to face-frame and frameless cabinets, finished in nickel and built to handle doors up to 1-5/16 inches thick with a screw-on mount that holds where it counts.
The 5/8 inch overlay is the geometry two doors share on a single center partition: each door covers about half the partition edge, meeting its neighbor with a consistent reveal. This hinge carries that configuration through a half crank arm, so the door lands at the right position relative to the cabinet side without additional shimming. It works on both frameless box cabinets and face-frame construction, giving the same result on either type of box. A matching Sugatsune base plate mounts to the cabinet, ordered separately, and the hinge arm screws onto it. The opening arc tops out at 93 degrees, the angle engineered to let a door in the thicker range clear the cabinet face cleanly through the full swing.
Nickel sits in the middle of the hardware finish spectrum: warmer than chrome, cooler than brass, and versatile enough to coordinate with brushed nickel pulls, satin knobs, and polished nickel fixtures without dominating the room. The steel body gives the hinge its rigidity and load capacity. The pair is rated to 55 pounds, so the weight of a solid hardwood door in the thick range stays within spec. Screw-on mounting contributes to the overall firmness of the connection: unlike a clip-on arm that can be unintentionally released, the screw-on seat stays put under repeated use and heavy door loads.
This hinge is the right call when the door stock runs thicker than the 16 to 22mm range that standard concealed hinges handle. The 40mm cup and 15mm cup depth are sized for that application, and the 93 degree opening is the correct arc for that geometry. Cabinet shops running face-frame boxes with thicker overlay panels, and remodelers matching existing hardware to a nickel finish scheme, will find this hinge covers both requirements in one part. For doors at a standard 3/4 inch thickness with a different overlay, another J95 configuration is the better fit. And for those who need a damped, cushioned close rather than a spring pull, a soft-close version of this series handles that need instead.
No. The hinge arm mounts to a separate base plate that attaches to the cabinet, sold separately. Use a Sugatsune plate matched to this series and your cabinet construction.
The 93 degree arc is the correct engineering for thicker doors. A thicker door needs a reduced swing to clear the cabinet front without collision, and 93 degrees is what delivers that clearance. It is a design feature, not a shortcoming.
No. Self-close uses a spring to pull the door shut over the last few degrees of travel. Soft-close uses a damper to slow the door so it settles quietly. This hinge is self-close: the spring draws the door to a close but does not cushion it.
This hinge uses a 48mm boring pattern, which is different from the 45mm pattern common to many other concealed hinges. Confirm the bore spacing on your door before ordering, especially if you are replacing an existing hinge.
When the project calls for thicker doors at a 5/8 inch overlay on face-frame or frameless cabinets, and the hardware scheme runs nickel, this hinge delivers a reliable self-close and a finish that holds its place across the room.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  SLJ95-P6T-BN Mfr# J95-P6T-BN | Sugatsune J95 Hinge Mounting Plate Black Nickel, - J95-P6T-BN |
