Würth #7 x 1-1/2" Modified Pan Head Face Frame Screw Square Drive - Type 17 Auger Point Coarse Thread Lubricated, 3670000192961 500 - 500/Box

Face Frame Screw For Softwood and Sheet-Good Joinery at 3/4-Inch Stock

This Würth #7 x 1-1/2-inch Modified Pan Head Face Frame Screw is a coarse-thread pocket-hole screw built for face frame construction and cabinet box assembly in softwood, plywood, MDF, and similar engineered panels. The 1-1/2-inch length is sized for standard 3/4-inch stock, making it a practical daily-driver for cabinet shops building pine, poplar, or plywood face frames.

Key Features

• Modified pan head seats flat against the joint face without wedging or splitting the workpiece.
• #2 square drive is designed to hold the screw on a correctly sized bit for one-handed placement in tight pocket positions.
• Type 17 Auger Point cuts into wood fibers with a fluted tip to reduce driving torque and lower the risk of splitting near edges.
• Coarse thread is optimized for softwoods, plywood, MDF, melamine, and particleboard to deliver strong withdrawal resistance.
• Lubricated finish reduces friction during installation, making repeated driving in production runs noticeably easier on the tool and the operator.
• 500 screws per jar keeps a working supply on hand without constant restocking interruptions.

Where This Length Works Best

The 1-1/2-inch length is the standard specification for joining 3/4-inch face frame stock with pocket-hole joinery. At this depth, the screw pulls rails tight to stiles and clamps face frames to cabinet boxes without blowing through the opposite face. It also works well for fastening plywood drawer boxes, attaching cabinet backs in 1/2-inch material, and securing shelf pin strips inside cabinet panels. Shops running softwood or sheet-good face frames in poplar, pine, plywood, or MDF will find this length covers most of their daily joinery needs.

Modified Pan Head and Square Drive

The modified pan head provides a broad, flat bearing surface that pulls the joint together cleanly. Unlike a bugle or countersunk head, it does not act as a wedge in face frame stock, which means less splitting risk at the stile edge. The #2 square drive recess is designed to hold the screw on a correctly sized bit, which helps when reaching into pocket holes at awkward angles on a cabinet run. The lubricated finish works alongside the Type 17 Auger Point to reduce the torque needed at each fastening point, which matters when driving several hundred screws in a production day.

Built for Cabinet Shops and Working Contractors

This screw is a natural fit for cabinet shops building face-frame cabinets in softwood species and sheet goods, as well as finish carpenters attaching pre-assembled face frames to cabinet boxes on site. The 500-screw jar keeps the supply accessible at the bench or in a work bag without the bulk of a full box. Production shops moving through face frames quickly will appreciate the consistent torque behavior that the lubricated finish and square drive deliver across a long run of identical joints.

Common Questions

The Right Screw for a Full Day of Cabinet Joinery

When the job is softwood or sheet-good face frames and the stock is 3/4 inch, this Würth #7 x 1-1/2-inch screw covers the joint from setup to final pull-down with the drive engagement, point geometry, and thread form to keep the work moving.