Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Quickscrews #6 x 1/2" flat head hinge and drawer slide installation screw is sized for mounting European cup hinges and drawer slides to cabinet panels where a longer screw would penetrate through to the finished face. The 1/2" length keeps fasteners secure and flush without breaking through 3/4" or thinner cabinet material.
Hinge mounting plates and drawer slide brackets are designed for screws in a specific length range. When panel thickness is 1/2" or the hardware backing sits close to a finished surface, a standard 5/8" or 3/4" screw can push through the far face and mar the visible interior. The 1/2" length of this screw eliminates that risk while still threading fully into the panel material behind the mounting plate. It is the right call for thin cabinet sides, overlay door installations, and any hardware position where panel depth is limited.
The steel shank carries a zinc electroplate finish that handles the dry conditions inside a finished cabinet without surface rust. The flat head profile matches the countersunk entry holes in most European hinge baseplates and drawer slide mounting brackets, so the head sits flush with the hardware face after driving. Coarse thread provides reliable engagement in the plywood, MDF, and particleboard that make up the majority of production cabinet carcasses.
Cabinet shops installing European hinges and undermount or side-mount drawer slides in volume go through hinge and slide screws quickly. This box is sized for that pace, with 5,000 screws supporting extended production runs without a reorder interruption. Installers working on site with pre-assembled cabinets find the sharp point useful for self-starting in the hardware holes without stopping to drill pilots. The #2 Phillips drive is compatible with any standard screw gun or cordless drill already on the bench.
Yes. The threaded portion engages the panel material fully even at 1/2" length, and hinge plates and drawer slide brackets are designed to distribute load across multiple screw points rather than relying on any single fastener for shear strength.
Most European hinge mounting plates and drawer slide brackets are pre-bored for a #6 gauge screw. This screw matches that spec directly.
No. The head seats into the countersunk recess already formed in the hinge plate or slide bracket. You are driving into the hardware's own hole, not into bare panel material.
The #6 x 1/2" size works wherever a short flat-head Phillips screw with coarse thread is called for in cabinet hardware installation, including shelf pin mounting strips and light surface-mount hardware with pre-bored countersunk holes.
A #2 Phillips bit. That is the standard size for #6 gauge screws and is found on most installation screw guns and cordless drills used in cabinet work.
When the job calls for mounting hinges and drawer slides in panels where depth is tight, having the correct 1/2" length on hand means the work moves without rework. Five thousand screws per box keeps that supply steady through a full production run.
Sold In: 5000 Each