Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Pro Value Series Mission Columns program decorative column brings a clean tapered Mission profile to exposed island ends, peninsula returns, and cabinet panel faces in unfinished maple.
A 3 by 3 inch section at 36 inches tall is proportioned for the end of a kitchen island or the return of a peninsula, where the column face is visible from multiple angles rather than pressed flat against a run of uppers. The tapered Mission profile gives the piece a deliberate architectural presence: a squared section that steps down toward the base, which reads as intentional joinery rather than applied trim. At standard counter height, this column sits cleanly under a countertop overhang without requiring any height modification for most island builds.
This is a decorative applied column. It is not a structural post, it carries no load rating, and it is not a substitute for engineered support. Its job is to finish the visible face of an island or cabinet end.
Maple is a close-grained hardwood with a consistently pale, even tone that takes paint or stain without the blotchiness that open-grained species can show. In a cabinetry program built from maple, the column and the door faces start from the same base, which makes the finish result more predictable. The piece arrives unfinished, giving the shop or installer full control over the final color and sheen. Because grain and tone vary naturally from piece to piece, this column is best finished alongside the surrounding cabinetry rather than matched to it after the fact.
Cabinet shops building maple kitchen programs reach for this piece when the island design calls for a visible column end rather than a plain panel. Designers specifying Mission-influenced kitchens use it to carry the tapered-leg vocabulary of the style up through the vertical elements of the island base. Contractors and installers working from a set of drawings that calls out a column at an island end will recognize the 36 inch height as the standard counter-height dimension and fit it into the build without modification. The square 3 by 3 inch section suits applications where the column is freestanding-looking rather than flush-applied.
At 3 inches deep and 3 inches wide, this is a square section rather than a thin split piece. It is applied to the end panel of an island or cabinet run, presenting a full-face column rather than a half-section veneer.
No. It is a decorative wood column with no stated load rating. It finishes the face of a panel; it does not function as a structural post or a countertop support.
Maple works best when the surrounding cabinetry is also maple. Its tight grain and pale, consistent tone make finish results more uniform across a run. If the cabinet doors are alder or cherry, the matching species column is the better fit.
Unfinished. Stain, paint, or topcoat is applied after installation to match the surrounding cabinetry.
When the island end needs a column and the build is maple, this piece puts the right species, the right style, and the right counter height in one order.