Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Karran bevel bit is a 1/2-inch shank router bit designed specifically for cutting and finishing solid surface material, producing a clean 45-degree beveled edge around sink cutouts and countertop openings.
A solid surface sink installation calls for tight tolerances at the edge where the sink meets the countertop. The 45-degree bevel at that junction is a critical detail: it creates the mating angle for a seamless, bonded join between the underside of the countertop and the sink rim. This bit produces that bevel in a single router pass. The over-sized bearing rides along the material edge and keeps the cut consistent without the guesswork of a freehand pass, which is especially important when both the countertop and the sink are visible-grade solid surface that cannot be rescored or patched.
Solid surface material cuts differently from wood or laminate. It loads heat into the bit faster and telegraphs any chatter or inconsistent depth into the finished edge. This bit is configured for that material specifically, with the bevel angle and bearing size matched to the geometry of a Karran solid surface sink installation. Using a router bit not rated or profiled for solid surface risks burning, tearout, or an edge profile that will not bond cleanly.
Cabinet shops and countertop fabricators installing Karran solid surface sinks are the primary users. It also suits kitchen designers or installers who source their own tooling and want a bit that matches the sink manufacturer's intended geometry rather than adapting a general-purpose profile. Because it runs on a 1/2-inch shank, it works with any router or router table collet set up for that shank size, which covers most professional-grade machines in a cabinet or countertop shop.
The over-sized bearing rides along the edge of the material and controls how deep the bevel runs. It acts as the depth stop so the cut stays consistent around the full perimeter of the opening without repositioning or manual adjustment.
This bit is designed and profiled for solid surface material. Using it on laminate, tile, or stone is outside its intended application and may produce unexpected results or damage the bit.
Yes. A 1/2-inch shank fits any router or router table with a 1/2-inch collet, which is standard on most professional-grade routers used in cabinet and countertop shops.
When the quality of a solid surface sink installation hinges on a precise, consistent bevel, this Karran bit delivers the geometry the material and the sink system require.
Sold In: 1 Each