Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Karran bevel router bit is purpose-built for cutting the 24-degree bevel required when installing solid surface sinks. It runs on a 1/2-inch shank and carries a bearing to guide the cut, keeping the profile consistent along the full edge.
When fitting a solid surface sink undermount, the countertop or sink edge needs a precise bevel so the two surfaces meet cleanly at the joint. The bearing on this bit rides the edge of the material and holds the cutting depth constant as you move through the cut, which means the bevel angle stays at 24 degrees across the full run. That consistency is what makes the joint tight and keeps the finished seam from showing a gap or ledge after the sink is bonded in place.
The bit is built from stainless steel, a material choice that holds up better than standard carbon steel in solid surface work, where the material's acrylic resin content can generate heat at the cutting edge. The stainless construction keeps the bit serviceable across repeated jobs rather than degrading quickly through a single project.
This bit is the right tool for fabricators and installers working with Karran solid surface sinks, and for countertop shops handling solid surface material on a regular basis. The 1/2-inch shank suits a professional router setup, whether table-mounted or handheld, and the bearing-guided design reduces the skill margin needed to run a consistent bevel. If the install plan calls for a solid surface undermount and the countertop is being cut and finished on-site or in the shop, this bit handles the profile work that step requires.
Yes. It is compatible with any standard router or router table accepting a 1/2-inch shank bit.
The 24-degree angle is the geometry that allows the sink and countertop faces to meet at the right profile for a bonded undermount joint. Using the correct angle produces a tight, even seam; the wrong angle leaves a visible gap or an uneven joint line.
This is a single 24-degree bevel bit. Other bevel angles in the Karran solid surface bit line are available as separate SKUs.
It is designed and spec'd for solid surface material. Use on other materials is outside the intended application and may produce different results.
For fabricators and installers who need a clean, repeatable 24-degree bevel on solid surface material, this Karran bit delivers the angle and the bearing control to get the joint right on the first pass.
Sold In: 1 Each