Hettich KA4620 24" Side Mount Over-Travel 200 lb Ball Bearing Drawer Slide, Zinc, 9019960

A 200 lb Over-Travel Drawer Slide Built for Deep Cabinets and Overhanging Worktops

This is a 24 inch (600mm) side-mount ball bearing drawer slide from Hettich's KA 4620 series, rated 200 lb and engineered with 1-1/2 inches of over-travel so the drawer clears countertop overhangs and deep face frames that stop a plain full-extension slide short.

Key Features

• 200 lb weight capacity — rated well above the standard 100 lb cabinet class, so heavily loaded shop and storage drawers are well within spec.
• 1-1/2 inch over-travel — the drawer member travels 1-1/2 inches past full extension, pushing the drawer clear of overhanging countertops and thick face frames.
• 24 inch (600mm) slide length — sized for deeper cabinets and full-depth utility drawers where shorter slides fall short.
• Steel ball bearing construction — hardened ball bearings in full-length raceways deliver smooth, consistent telescopic travel under heavy load.
• Non-handed design — both slides in the pair are identical; no left or right sorting required on the bench.
• Zinc finish — standard electroplated zinc protects the steel members for lasting indoor service.

Where the Extra 1-1/2 Inches Makes the Difference

A plain full-extension slide brings the drawer to the cabinet face and stops. Under a countertop overhang or behind a deep face frame, that means the rear of the drawer is still blocked. The KA 4620's over-travel pushes the drawer 1-1/2 inches past that point, so the back contents are actually reachable. This matters most in workbenches with thick tops, kitchen base cabinets under stone or butcher-block overhangs, and utility cabinets where a deep face frame eats into the opening. The 24 inch slide length also suits full-depth cabinets where shorter slides would leave wasted space behind the drawer.

Steel Construction With a Zinc Working Finish

The KA 4620 is built from cold-formed steel with a zinc electroplate finish. Zinc is the functional standard for side-mount ball bearing slides: it handles the wear of repeated open-close cycles and protects the steel members through years of indoor use. This is not a decorative finish and it is not stainless — keep it dry and indoors. The slide is a standard-motion design, meaning there is no soft-close damper, no self-close spring, and no detent. The drawer stays wherever it is left and closes with a normal push.

The Right Fit for Heavy Drawers Under Deep Overhangs

Choose the KA 4620 24 inch when two things are true at once: the drawer is heavy, and the cabinet sits under an overhang or behind a deep frame. At 200 lb capacity, this slide handles loaded shop drawers, heavy kitchen pull-outs, and utility storage that would push a standard 100 lb cabinet slide to its limit. The non-handed design means the same slide goes on either side — order the quantity your drawer count requires. For face-frame cabinet installations, rear mounting support is needed at the back of the slide; confirm the appropriate bracket for this series before building.

Heavy Capacity and True Over-Travel, Ready to Install

When the drawer is deep, the load is real, and a standard slide won't reach past the overhang, the KA 4620 in 24 inch gives you the capacity and the extra travel to do the job right.