Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the right-hand, screw-on rear mounting bracket for the Hettich Quadro V6 undermount drawer slide system, designed to anchor the slide's back end inside face-frame cabinet construction. Sold in a box of 100, it is a dedicated Quadro component and does not interchange with other Hettich series or third-party slide systems.
Face-frame cabinets set the cabinet side back from the front frame, leaving the rear of the drawer slide unsupported unless a rear mounting bracket bridges the gap. Without this bracket, the back of the Quadro V6 slide has no fixed reference point, which affects drawer alignment and smooth travel. This right-hand bracket anchors the slide's rear end to the cabinet side panel so the full 2D adjustment range at the front locking device works as intended. It belongs in any face-frame build where the Quadro V6 is the specified undermount system.
The bracket is molded plastic, a deliberate material choice for a part that positions rather than carries load. It screws to the cabinet panel without requiring specialized boring equipment, which makes it straightforward to install in shops without CNC line-boring setups. Compatibility is strictly Quadro V6: the engagement geometry is version-specific, and brackets from earlier Quadro generations or other Hettich undermount lines will not produce a correct fit. If your project uses a different Quadro version, confirm the bracket series before ordering.
Cabinet shops specifying Quadro V6 slides in face-frame work need rear brackets on every drawer; this right-hand bracket covers one side. Production environments benefit most from the 100-count box — a run of 50 drawers consumes the full box across both sides, so having the right-hand quantity on hand keeps the line moving. Smaller shops completing a single-cabinet project may want to confirm the quantity needed before ordering at this pack size. This bracket is not for frameless installations, where the Quadro V6 mounts directly to the side panel without rear support hardware.
Yes. Each drawer requires one right-hand and one left-hand rear bracket, one per slide. This listing covers the right-hand side only; order the matching left-hand bracket separately to complete the pair.
No. Rear mounting brackets are a face-frame requirement. In a frameless cabinet, the Quadro V6 slide mounts directly to the side panel, and a rear bracket is not part of the installation.
No. The bracket is specific to the Quadro V6 platform. Quadro versions use different engagement geometry, and brackets are not interchangeable across generations. Match the bracket to the exact slide series in your project.
The 2D refers to the adjustment capability supported at the Quadro V6 front locking device — height and side adjustment. This rear bracket is the anchor that makes those front adjustments accurate; the bracket itself positions the slide, while adjustment is made at the front.
A missing or wrong rear bracket is one of the most common reasons a face-frame drawer installation stalls. Stocking the correct Quadro V6 right-hand rear bracket in production quantities means the back of every slide lands where it belongs, the front adjustment does its job, and the drawer runs true from day one.
Sold In: 1 Each